Do you have a question about the 112-3089-0E and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Sonetics 112-3089-0E
Page 1
Wireless Base Station 1-User and 4-User Operation Manual C O R P O R A T I O N 7340 SW Durham Road Portland, OR 97224 USA Phone: 503-684-7080 Fax: 503-620-2943 www.soneticscorp.com email:sales@soneticscorp.com...
The base station can be connected POWER INTERCOM PAIR via a 6 conductor flat cable to any headset port in Sonetics’ 10 Series intercoms. The base Single Headset Base Station station will provide full duplex audio and PTT 112-3094-0E communication between the wireless headset or belt pack and the intercom.
INSTALLATION • It is recommended that the base station be mounted high inside the vehicle, not within 10.2cm of any metal . The base station should be attached to a flat surface with 6.35mm thick, double-sided tape, to help insulate the base station from the cold.
PAIRING LINK WIRELESS BASE POWER INTERCOM PAIR 1-User Base Station 1-User Base Station 1.When the base station is first powered, the green LED labeled POWER on the bottom left of the front panel will illuminate steadily. The single LINK yellow LED will either stay unlit, indicating that no headset / belt pack have been previously paired to the base, or will start flashing rapidly, indicating that a headset / belt pack has been previously paired to the base station...
Page 6
PAIRING LINKS 1 2 3 4 5 WIRELESS BASE POWER INTERCOM PAIR 4-User Base Station 4-User Headset Base The 4-User base station is equipped with 5 yellow LINK LEDS on the front panel. Each LINK LED represents a headset / belt pack position with position #1 represented by the left-most LED.
PAIRING 3.Place the headset or belt pack in pairing mode; refer to the applicable user’s manual for information regarding how to put the unit in pairing mode. The red and green LEDs on the headset / belt pack will alternate rapidly to indicate that the unit is in pairing mode.
Note: If the symptoms you are experiencing are not covered in this manual, or if you are having difficulty troubleshooting your system, contact your local Sonetics dealer for assistance or see www.soneticscorp.com for additional information. Problem: No indication of power to the base station (green power indicator does not illuminate).
- Up to a total of 120 headsets / belt pack combinations connected simultaneously in close proximity. Meets Essential Requirements of: EN 301 406 V1.5.1 EN 489-6 V1.3.1 IEC 60950-1: 2005 EN 60950-1: 2006 Changes or modifications not expressly approved by Sonetics can void the user’s authority to operate the equipment.
- 110 / 210 intercom to dual base adapter cable: P/ N 420-2143-00 - Power supply, international wall adapter: P/ N 114-0061-0E If a problem persists in the device, contact Sonetics for a Return Merchandise Authorization (RMA) number. Return the device for replacement or repair.
Need help?
Do you have a question about the 112-3089-0E and is the answer not in the manual?
Questions and answers