Power Supply Module; Removing The On/Off Switch Cable From The Power Supply - DEC VR315 Service Manual

Monochrome monitors
Table of Contents

Advertisement

3–8 Removing and Replacing FRUs

3.2.2 Power Supply Module

Remove the power supply module as follows:
1. Remove the rear cover (Section 3.1.2).
2. Remove the top cover (Section 3.1.3).
3. Remove the interconnect cable (Section 3.2.1).
4. Disconnect the 3-wire, 5-pin On/Off switch cable (P4) from the
connector (J4) at the top of the power supply by pressing the tab
on top of the connector (Figure 3–6).
Figure 3–6

Removing the On/Off Switch Cable from the Power Supply

3 - W i r e , 5 - P i n ,
O n / O f f S w i t c h
C a b l e
P o w e r
S u p p l y
M A - 0 2 3 0 - 9 0 . D G

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vr325

Table of Contents