Advertisement
Figure 1
G
Attention should be given to ensure that any applicable regulations
concerning discharge of exhaust air are fulfiled.
G
This appliance should be installed and maintained by a suitably qualified and
competent person in accordance with the relevant safety regulations.
G
Before connecting the appliance to the mains supply, ensure that the voltage
and frequency details on the rating plate are consistent with the source of
supply.
Installation
As stainless steel hoods scratch and mark
easily, carefully remove the protective plastic
film from all exterior surfaces of the hood and
chimney only prior to final installation.
At least two people will be required to mount
the hood.
Installing the hood
G
The cooker hood should be placed at a
height of 65cm above an electric hob or
75cm above a gas hob (see Figure 2).
G
Secure the hood mounting bracket to
the wall using the two ST5 x 50mm mounting screws and dry wall anchors.
Align the hood body with the hood mounting bracket. Gently lower the hood
until it securely engages the bracket. (see Figure 3, opposite).
G
Ensure the hood is level then fasten the hood body with the two screws at the
rear.
4
Figure 2
G
If using the hood in air extraction mode
fit the discharge collar (non-return flap)
into the air outlet adaptor (see Figure 4,
right).
G
For air extraction mode, attach an
adequate length of 150mm duct
(supplied) to the air outlet termination,
and connect the duct to the vent (on
wall or ceiling) (see Figure 5, right).
G
Connect the mains supply.
G
Fix the chimney mounting bracket to
the top Decorative Chimney piece with
chimney bracket screw.
G
Carefully place the decorative chimney
bottom into the recessed area of the
hood body top (see Figure 5, right)..
G
Carefully slide the decorative chimney
top up inside the decorative chimney
bottom. Secure the chimney mounting
bracket to the wall using the ST5 x
50mm mounting screws and dry wall
anchors and located on the wall.
Figure 5
Figure 3
Figure 4
Figure 6
5
Advertisement
