Table of Contents
Advertisement
Available languages
Available languages
38 SPECIFICATIONS
SPECIFICATIONS
MOd_l_
DLBOSo_ DL_Z051*
Description
Dryer
Electrical requirements*
Please refer to the rating label regarding detailed information.
Gas requirements*
NG 4-10.5 inches WC
LP:8-13 inches WC (Gas Models only)
Dimensions
27" (W) X 30" (D) X 38W16"(H), 51" (D with door open)
68.6 cm (W) X 76.1 cm (D) X 98.3 cm (H), 129.7 cm (D with door open)
Net weight
Elec : 123.5 Ib (56.02 kg)
Gas : 126.2 Ib (57.23 kg)
Drying capacity
IEC 7.1 cu. ft. (22.5 Ib / 10.2 kg)
USING
SMARTDIAGNOSIS
TM
- SMARTDIAGNOSIS
TM
cannot be activated if the dryer does not power up, If this happens, then troubleshooting must be done without
SMARTDIAGNOSIS
TM,
- SMARTDIAGNOSIS
TM
is a troubleshooting
feature designed
to assist, not replace, the traditional
method
of troubleshooting
through
service calls. The effectiveness
of this feature depends
upon various factors, including,
but not limited
to, the reception
of the
cellular phone being used for transmission,
any external
noise that may be present
during the transmission,
and the acoustics of the
room where the machine
is located.
Accordingly,
LG does not guarantee
that SMARTDIAGNOSIS rMwould accurately
troubleshoot
any given issue.
If you experience
problems
with your dryer, call 1-800-243-0000
(1-888-542-2623
in Canada). Follow the call center agent's instructions,
and do
the following
steps when requested:
1. Press _
to turn on the dryer. Do not press any other buttons.
2. When instructed
to do so by the call center agent, place the mouthpiece
of your phone very close to the POWER button.
3. Press and hold @
(Temp.Control)
for three seconds, while holding
the phone mouthpiece
to the icon or POWER button.
4. Keep the phone
in place until the tone transmission
has finished. This takes about 6 seconds, and the display will count down the time.
, For best results, do not move the phone while the tones are being transmitted
and do not touch the control panel with the phone.
, If the call center agent is not able to get an accurate recording
of the data, you may be asked to try again.
, Pressing the POWER button
during
the transmission
will shut offthe
SMARTDIAGNOSIS
TM,
5. Once the countdown
is over and the tones have stopped,
resume your conversation
with the call center agent, who will then be able to assist
you using the information
transmitted
for analysis at the call center agent.
Hide quick links:
Advertisement
Chapters
Table of Contents
