Download Print this page

Safety Instructions; Technical Specification; Maintenance - Vax V-303 Wash "N' Dry Instruction Manual

Advertisement

1. Safety Instructions

For Household Use Only
When using the cleaner, basic safety
precautions should always be observed,
including the following:
1. Do not leave the machine unattended
when plugged in. Unplug it from socket
when not in use.
2. To prevent injury do not use outdoors.
3. Not to be used as a toy. Children should
be supervised to ensure that they do not
play with the appliance.
4. This appliance is not intended for use
by young or infirm persons unless they
have been adequately supervised by a
responsible person to ensure that they
can use the appliance safely.
Young children should be supervised
to ensure that they do not play with the
appliance.
5. Use only as described in this manual.
6. Do not use with a damaged cord or plug.
If the supply cord and/or plug is damaged,
they must be replaced by a Vax Service
Agent or similarly qualified persons in
order to avoid hazard.
7. Do not pull or carry by the cord, use the
cord as a handle, allow the cord to come
into contact with hot or sharp surfaces or
close a door on the cord.
8. Do not unplug by pulling on the cord.
9. Do not handle the plug or machine with
wet hands.
10. Do not put any objects into openings or
operate with openings blocked, keep
them free of anything that may reduce
airflow.
11. Keep hair, loose clothing, fingers and all
parts of the body away from openings
and moving parts.
12. Do not use the machine on any glowing,
burning or smoking particles.
13. Do not use without the solution tank and
dirty water tank in place. OR
14. Do not use the vacuum without the dust
bag in place.
15. Turn off all controls before unplugging.
16. Do not use to pick up flammable or
combustible liquids such as petrol, or use
in areas where they may be present.
2
17. Keep the unit on the floor.
18. Do not use an extension cord.
19. Do not attempt to remove blockages
with sharp objects as they may cause
damage.
20. Store indoors put away after use to
prevent tripping accidents.
21. Using improper voltage may result in
damage to the motor and possible injury
to the user. The correct voltage is listed
on the rating label.
22. A hazard may occur if the machine runs
over the power supply cord.
23. To prevent dirty water from running into
motor, do not hold the appliance upside-
down or lay on its side.
Use appliance in normal vacuuming
position.
24. Use extra care when cleaning on stairs.
25. Do not carry appliance while motor is
running.
NOTE: Carpets should be dry vacuumed
thoroughly before washing.
NOTE: The unit must be unplugged from
the mains socket outlet after use, and before
cleaning or maintaining the unit.
IMPORTANT: This unit is not intended
for commercial use.
PLEASE KEEP THESE INSTRUCTIONS
FOR FURTHER USE.

Technical Specification

Voltage:
220-240V~50Hz
Wattage:
1300W
Capacity:
Clean water tank - 4 litres
Dirty water tank - 5.2 litres
Cord length:
7.5m
Weight:
7.7kg
Subject to technical change without notice.

11. Maintenance

IMPORTANT: Ensure that the machine
is switched off and unplugged from the
socket before carrying out any maintenance.
Cleaning the Pre-Motor Filter.
1. Remove the motor top from the unit, turn
on its side and remove the float housing
in an anti-clockwise direction to unscrew
(Fig.10/1).
Fig.10/1
2. Remove the blue filter (Fig.10/2) and wash
under a tap. Allow to dry thoroughly before
replacing back into the machine. Replace
with a new filter as necessary.
Fig.10/2
3. Turn the float housing in a clockwise
direction until secure and place the motor
top back onto the unit.
Cleaning the Post-Motor Filter
1. Remove the filter housing at the back of the
machine (Fig.10/3).
Fig.10/3
2. Remove the filter (Fig.10/4) and wash
under a tap. Allow to dry thoroughly before
replacing back into the machine.
Fig.10/4
3. Once dry, put the filter back into the housing
and place back into the machine.
Cleaning the Pleated Pre-Motor Filter
Assembly
1. Remove the filter by twisting gently. This
will release it from the motor housing
(Fig.10/5).
Fig.10/5
2. Clean by tapping it against the side of a bin
or by brushing gently.
NOTE: Do not wash this filter. Replace every
9-12 months as needed.
11

Advertisement

loading