Specifications - LG DLEX8501 Series Owner's Manual

46
SPECI FIC£_iTIONS
Before calling for service (conf.)
Problem Possible Causes Solutions
Steam does not . Water level error. . Unplug dryer and call for service.
generate but no error
code is shown
Garments still . Too many or too different types of garments . Small loads of 1 to 5 items work best.
wrinkled after in dryer. . Load fewer garments. Load similar-type garments.
Steam Fresh
TM
There are no creases . The function of this cycle is to remove . Use an iron to make creases.
left on garment after wrinkles from fabric.
Steam Fresh
TM
Garments have .This is normal. . Depends on individual moisture level in skin.
static after
Reduce Static
Garments are too . Correct drying options not selected. . Select load weight manually before starting Reduce Static option.
clamp or too dry after
Reduce Static
Garments are not . Number of garments or load size not properly . Select the correct number or garments or load size before starting the cycle.
uniformly clamp after selected at the beginning of the cycle.
Easy Iron
Water drips from door . This is normal. . Condensation will normally form on the inside of the dryer door during steam
during Steam Cycle operation. Some condensation may drip out the bottom of the door.
Steam is not visible . This is normal. . Steam vapor is difficult to see when the door is closed. However, condensation
during Steam Cycle will normally form on the inside of the dryer door if the steam system is
operating normally.
Drum does not turn . This is normal. . The drum is turned off so that the steam vapor remains in the drum.The drum
during Steam Cycle will normally turn for about 2 seconds once a minute.
Cannot see steam • This is normal. • Steam is released at different stages of the cycle for each option.
vapor at the
beginning of cycle
The display shows . More Time button pressed. . This display indicates that the steam option has been set for a"Load Bulky
Load Bulky items items"item such as a comforter.
Press the LESS TIME button to reduce the indicated load size.
Odors remain in . Steam Fresh
TM
did not remove odor . Fabrics containing strong odors should be washed in a normal cycle.
clothing after completely.
Steam Fresh
TM
. Lint filter is almost clogged or full. . Pause the drying cycle and clean the lint filter.
. Install a shorter or straighter duct run. See the Installation Instructions.
CHECK FILTER light
is on during the
drying cycle
Flow Sense
TM
indicator shows four
bars during the drying
cycle
. Ductwork is too long or has too many turns/
restrictions.
. Significant blockage of the ductwork due to
lint buildup or debris.
. The appliance has detected a restriction in
the external dryer venting.
. Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may be longer.
TM
. If exhaust restrictions are sensed by the FLOW SENSE system, the indicator
will remain on for two hours after the end of the cycle. Opening the door or
pressing the POWER button will turn off the display.
SPECIFICATIONS
Description Steam Dryer
Electrical Requirements _ Please refer to the rating label regarding detailed information.
Gas Requirements _ NG: 4-10.5 inches WC
LP: 8-13 inches WC (Gas Models only)
Dimensions 29"(W) x 32.1 "(D) x 40.8"(H) x 59"(D with door open)
73.6 cm (W) x 81.4 cm (D) x 103.6 cm (H) x 151.8 cm (D with door open)
Net Weight Gas : 161.21bs(73.1 kg), Electrical : 155.41bs(70.Skg)
Drying Capacity
- Steam Cycle IEC 9.0 cu.ft(81b/3.6kg)