Samsung WA52J8060A Series User Manual page 25

*
STEP 4 Leveling your washer
WA8000J_WA8700J_WA52J-03133Y-01_EN.indd 25
A
A
NOTE
Connect the hose guide (A) within 4 in (10
cm)* from the end of the drain hose. If the
drain hose is extended more than 4 in (10
cm) beyond the end of the hose guide, mold
or microorganisms could spread to the
inside of the washer.
NOTE
The drain hose can be installed to a 96
in (245 cm) maximum, but the draining
capability can be reduced at this height.
It can cause the washer to have an odor
because of remaining water in the drain
system.
NOTE
If the drain hose is installed below 39 in (99
cm), water can be drained in cycles due to a
siphon phenomenon. It causes the washer to
display "4C".
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below the
pulsator level.
NOTE
WA52J8700A* models have the Built-in sink
over the pulsator level. That's why the level
is not revealed. Open the Built-in sink and
check the level with eyes.
English 25
2015/4/20 15:33:46