Page 3
*Manual trigger available for 10 MHz (100 ns) rate only. Not available with any other rate settings.
Page 6
(Note: If using manual trigger, 10 MHz must be selected. Manual trigger is not available in any other rate ranges.) *Manual trigger available only when rate is set to 10 MHz (100 ns) only. Not available with other rate ranges.
Page 7
TROUBLESHOOTING Using Manual Trigger In order to use the manual trigger, you must have the "Rate" switch in the 10M/100nS position. This is the only way to access the manual trigger function. If you set the Rate switch to the 10M position and the "Width" switch to the 50mS and the "Mode" switch to manual trigger, then set the volt/division switch on your O-Scope to 2V or 5V and your time/division respectively at 50mS.
Need help?
Do you have a question about the 4030 and is the answer not in the manual?
Questions and answers