evo Medical Solutions Aeroneb GO 7010 Quick Start Manual

QUICK START INSTRUCTION
GUIDE BEGINS HERE

TO ASSEMBLE NEBULIZER UNIT

STEP 1
Before you begin, run the Medication Cup
under hotwater, then tap the cup slightly.
STEP 2
Connect the Medication Cup (containing the
OnQ ® Aerosol Generator) to the Nebulizer Body.
NOTE: Make sure the Aeroneb Go is unplugged
before you add medication to the Medication
Cup.
STEP 3
Fill the Medication Cup with the prescribed
nebulizer medication. Never pour more than
6 mL into the cup. The continuous line on
the inside surface of the cup indicates the
maximum filling level. (When the medication
cup contains medication, the cup should
remain in an upright position). CAUTION: To
avoid damage to the nebulizer unit, do not use
a syringe with needle.
STEP 4
Securely place Cap on Medication Cup.
STEP 5
Attach Mouthpiece or Mask Connector and
mask to Nebulizer Body. NOTE: Masks are an
optional accessory and may be purchased
evo
through Medical Solutions or your
Aeroneb ® Go dealer.
CONTINUE TO PAGE 2
Follow the operating instructions that
apply to your specific model.
1
Aerogen and Aeroneb are registered
Aerogen (Ireland) Limited,
trademarks of Aerogen, Ireland Ltd.
Galway Business Park,
Dangan,
evo
©2007 Medical Solutions
Galway.
P/N 22262 Rev D Rx Only www.aerogen.com
Quick Start Card
ATTENTION:
To optimize the performance and life
expectancy of your Aeroneb Go device, follow the
cleaning instructions carefully as instructed on
page 11 of your Aeroneb Go Instruction Manual.
Medication Cup Cap
Mouthpiece
Battery Powered Controller AC/DC Controller
with detachable power cord with attached power cord
Model 7010 Model 7030
IMPORTANT CAUTION
As with any mechanical device, this product may become
unusable due to an electrical outage, battery depletion, or
mechanical failure. We recommend that you have spare
batteries and have a backup device available to you.
If this product is being used to treat a life threatening
condition, a backup device is necessary.
Retain this card with your device for future reference.
Ventilation Holes
Medication Cup
(with OnQ ® Aerosol
Generator)
Nebulizer Body
AC/DC Adapter
with attached power cord
Model 7090