GE AEW24DSL1 Owner's Manual And Installation Instructions page 11

JnstaJlationinstructions
FJ PREPARETHE CASE (continues)
r_ Attach the side retainers to the case using 6
type A screws.
[ PREPARE THEWINDOW AND INSTALL
THECASE
r_ cut the window sash seal to the proper length.
Peel off the backing and attach the seal to the
underside of the window sash.
r_Open the window and mark the center of
the window sill.
FCI Carefully slide the case into the window
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window stool. Mount the case
to the window sill using 2 type C screws.
Drill pilot holes, if necessary.
Stool
[]PREPARE THEWINDOW AND INSTALL
THECASE(continues)
F_ Assemble the V-support and V-support
bracket with Type F nut and bolt
Type Ebolt
nut
Left i
D
E1
Sill angle
bracket
_--_Q _
V-support Type
F bolt and nut
Right
Position the V-supports
on the case bottom so
that they will be near
the outside wall. Attach
a V-support to each side
of the bottom of the case
with Type E bolts, 2 for
each support.
Adjust sill an qle brackets to rest on sill.
ipport
r_ Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top corners with 2 type
C screws.
_L_2LII_t
Type C
screw
screw
11