Realistic Pro-30 Owner's Manual page 7

background noise between transmis-
sions. With no signal, turn clockwise
OFFNOLUME Control
-
Turn clock
wise for power ON. Further rotation
will increase volume.
I
EARphone Jack
-
For connecting an
EARphone. The built-in speaker is
I
automaticallv disconnected.
!
ANTENNA Jack
-
Connect the flexi-
ble antenna (supplied) to this jack.
I . I
REMOTE KEYS
I
SPEED Key
-
Selects scan and search
1
speeds: fast (10 chfsec) or slow
(5
chlsec).
I / /
SCAN Key
-
Sets the PRO-30 to
automatically scan each available
(PWR) Jack
MANUAL Key
-
Sets the PRO-30
to manually scan the channels. Each
Recharger
time the button is pressed, the Re.
ceiver will advance one channel.
The Battery Compartment holds the internal power source (6 type
AA batteries plus three silver oxide batteries for memory back-up).
External PoWeR Jack lets you connect an external source of 9 volts
DC (negative ground) for operation without batteries. Use our 273-
1455 for 120VAC, 14-844D for 12V Car operation. Mobile use of
scanners in some areas may be unlawful or require a permit. Check
with local authorities.
To recharge Nickel Cadmium batteries in the receiver, simply plug
an external 9 volt DC power source (Such as our 273-1455 noted
above) into the CHarGe JACK. To fully charge Nickel Cadmiums,
leave connected for 10-1 8 hours.
Cadmium batteries are installed in the receiver. Also, do not
attempt t o operate the unit while recharging Nickel Cadmiums.