vividtouch VTE-3200 Installation & Operation Manual page 46

Smart Light Control: Select Smart Light Control from the Advanced Settings menu and press
automatic backlight control feature of the display. Select one of the following, or select Off to control the backlight level
manually with the Backlight control in the Video Settings menu.
• Light Sensor: With this setting, the backlight level is controlled by the display's internal ambient light sensor.
• DCR: With this setting, the display automatically adjusts the backlight level according to the amount of contrast and
brightness in the source material.
• Wake Up From Sleep: Select Wake Up From Sleep from the Advanced Settings menu and press
this feature, which operates as follows:

VGA Only: The display normally wakes up from power-saving mode when it receives an active video signal on
its VGA (analog) input.

VGA, Digital, RS232: The display wakes up when it receives an active signal from its VGA, HDMI, DisplayPort
or DVI inputs, or receives a valid RS-232 command.

Never Sleep: The display never enters power-saving mode.
Ethernet Setup: Select Ethernet Setup from the Advanced Settings menu and press
settings.
• Enable Network: Enables the network feature.
Option: No, Yes.
• IP Address Settings: When network feature is enabled, press

Dynamic IP: Enable DHCP for dynamic IP address assignment.

Static IP Address: Sets the static IP address when the DYNAMIC IP line is disabled or views it when the
DYNAMIC IP line is enabled.
Range: 255.255.255.255 (0.0.0.0)

Subnet Mask: Sets the subnet mask when the DYNAMIC IP line is disabled or views it when the DYNAMIC IP
line is enabled.
Range: 255.255.255.255 (0.0.0.0)

Gateway: Sets the gateway address when the DYNAMIC IP line is disabled or views it when the DYNAMIC IP
line is enabled.
Range: 255.255.255.255 (0.0.0.0)

DNS Address: Sets the DNS address when the DYNAMIC IP line is disabled or views it when the DYNAMIC IP
line is enabled.
Range: 255.255.255.255 (0.0.0.0)

Save Network Settings: Saves the network configuration when the DYNAMIC IP line is disabled.
Options: No, Yes.

Refresh: Refreshes the configuraiton of Static IP Address, Subnet Mask, Gateway and DNS Address.
• Power Status Alert: sent when the unit is turned on or off.
• Source Status Alert: sent when a different source is selected.
• Signal Lost Alert: sent when the input sync is lost.
• Load Default: loads default network settings.
Options: No, Yes
to configure the display's network
to configure the following IP addresses:
or to configure the
or to control
46