Table of Contents
Advertisement
Quick Links
Gas Stove User
Instructions
Please leave this instruction booklet with the user after the installation is
complete. Leave the system ready for operation and instruct the user in
the correct use of the appliance and operation of its controls.
Please refer to the appliance data plate for the
specific model type.
RevC 11/04/13
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HS GAS Herald 6
Summary of Contents for HS GAS Herald 6
- Page 1 Gas Stove User Instructions Please leave this instruction booklet with the user after the installation is complete. Leave the system ready for operation and instruct the user in the correct use of the appliance and operation of its controls. Please refer to the appliance data plate for the specific model type.
- Page 2 1. Read all instructions carefully before attempting to operate this appliance. 2. If you have any doubts about the suitability of your chimney for the appliance please consult your local HS Gas stockist/dealer. The chimney must be given a precautionary sweep before connection to the appliance.
- Page 3 The ‘coals/logs’ may change colour after use, which is quite normal. • Replacement ceramic matrices and coals/logs must be sourced from your approved HS Gas stockist. Operating the Appliance It is strongly recommended that these instructions are read and thoroughly understood in advance of operating this appliance.
-
Page 4: Lighting The Appliance
IMPORTANT NOTE This appliance is fitted with an ‘oxygen depletion system’ (ODS) which constantly measures the level of oxygen in the room. If the concentration of oxygen drops below a safe level the appliance will automatically shut-off. The appliance is also equipped with a sensor to monitor the function of the flue (TTB Switch). - Page 5 Adjusting between High and Low Output Settings (Main burner). Make sure that the ON/OFF control knob (Knob A) is set to the ‘ON’ position and that the pilot flame has been established. The left hand control knob (Knob B in Diagram 2), controls the stove output.
- Page 6 Operating the Remote DISPLAY PANEL INCREASE BUTTON DECREASE BUTTON DIAGRAM 3 The remote control can be used to adjust the flame height and heat output of the appliance. The larger the flames the more heat is generated. The flame height can be adjusted using the ‘Increase’...
- Page 7 If required the stove can be polished using stainless steel cleaner. A GAS SAFE registered fitter must carry out servicing at least annually and where necessary replace unserviceable components with only genuine HS Gas parts. Aspen House, Pynes Hill, Exeter, EX2 5AZ www.hs-gas.co.uk...
Need help?
Do you have a question about the Herald 6 and is the answer not in the manual?
Questions and answers