Tait TMAA10-03 Installation Instructions

TMAA10-03/TMAA10-06
High-Power Remote Speakers
Installation Instructions
Introduction
TMAA10-03 remote speaker (for 25W
radios) and the TMAA10-06 remote speaker
(for 30-50W radios) are installed in parallel
with the radio's existing internal speaker.
The remote speaker can then be installed at
some distance from the radio, or it can
be used to increase the volume of the audio
from the radio's existing internal speaker.
The remote speaker is supplied with a socket
housing (already installed) and a flying lead
connector. This connector enables the
speaker to be easily removed and
reconnected as required.
The flying lead connector is terminated with
two receptacles. The receptacles supplied
with the TMAA10-03 (for 25W radios) are
different to those supplied with the TMAA10-06 (for 30-50W radios). Two spare
receptacles are included with each kit, along with four mounting screws and washers.
Installation
Remote Speaker Mounting
1 Choose a mounting position for the remote speaker where it will not interfere with the
operation of any of the vehicle controls.
2 Remove the remote speaker from the mounting bracket and use the screws and washers
provided to fix the mounting bracket securely in the chosen location.
Notice Check before drilling that the drill will not damage any components or wiring
behind the mounting location.
If mounting the bracket onto a metal surface, drill two 3.5mm (0.14 inch) holes in
■
the appropriate locations and secure the bracket with the supplied self tapping
screws.
If mounting the bracket to any other material, such as plastic, drill two 4.5mm
■
(0.18 inch) holes and attach the bracket with screws and captive nuts, or similar.
3 Attach the speaker to the mounting bracket using the thumbscrews.
© Tait Limited April 2012
www.taitradio.com
402-00010-04
mounting
bracket
socket
housing
receptacles
remote
speaker
cable
flying lead
connector