GMC Terrain 2011 Owner's Manual page 38

Hide thumbs Also See for Terrain 2011:
Table of Contents

Advertisement

2-4
Keys, Doors and Windows
For more information see Remote
Unlock Light Feedback under
Vehicle Personalization on
page 5 32. Pressing
may also
disarm the theft-deterrent system.
See Anti-Theft Alarm System on
page 2 13.
(Remote Liftgate Release):
First press
, then press and
hold
to unlock the liftgate.
For vehicles with the power liftgate,
press and hold
until the liftgate
begins to move to open the liftgate.
(Vehicle Locator/Panic
Alarm): Press and release
one time to locate the vehicle.
The exterior lamps flash and the
horn chirps. Press and hold
at least two seconds to sound the
panic alarm. The horn sounds and
the turn signals flash until
pressed again or the key is placed
in the ignition and turned to
ON/RUN.
(Remote Vehicle Start):
For vehicles with this feature, first
press
then press and hold
start the engine from outside the
vehicle using the RKE transmitter.
See Remote Vehicle Start on
page 2 5 for additional information.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to this vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
When the replacement transmitter
is programmed to this vehicle,
all remaining transmitters must
also be reprogrammed. Any lost or
for
stolen transmitters will no longer
work once the new transmitter is
programmed.
is
I n f o r ma t i o n P r o v i d e d b y :
Battery Replacement
Replace the battery if the REPLACE
to
BATTERY IN REMOTE KEY
message displays in the DIC.
See Replace Battery in Remote
Key under Key and Lock Messages
on page 5 29.
The battery is not rechargeable.
To replace the battery:
1. Push the button on the
transmitter to extend the key.
2. Remove the battery cover by
prying with a finger.
3. Remove the battery by pushing
on the battery and sliding it
toward the keyblade.
4. Insert the new battery, positive
side facing up. Push the battery
down until it is held in place.
Replace with a CR2032 or
equivalent battery.
5. Snap the battery cover back on
to the transmitter.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents