Portable Electric Scooter Electric two wheels A new era in urban mobility The most economical vehicle in history USER MANUAL Thank you for purchasing our products PLEASE CAREFULLY READ THE USER MANUAL AND WARRANTY BOOK BEFORE USING...
Page 2
AND WARNINGS IN THIS MANUAL. Check local laws and regulations to see where and how you may use your E-Twow scooter legally. Obey to all applicable laws for vehicles and pedestrians. This manual includes basic operational instructions for the E- Twow scooter.
CONTENTS MAIN PARTS SAFETY PRODUCTS Folding stages Folding steps Unfolding steps OPERATION Introduction of Handlebar parts Operation Instruction Display Factory settings RIDING OPERATION Ready Start Brake Cruise control Zero start BATTERY AND CHARGER Battery Charger Charge Description MAINTENANCE Lubricating Battery Placement and daily care GENERAL TROUBLESHOOTING PRODUCT SPECIFICATION SHEET...
SAFETY The product is for adults only (above 18 years), limited for one adult. Please do not carry two adults at the same time. Is not suitable for minors. Always inspect the scooter prior to use. Properly inspecting and maintaining your product can reduce the risk of injury.
Page 6
4 cm and do not wash it with water under pressure. 14. For protection please do not ride the scooter in bad weather such as heavy rain and high winds. 15. Do not drink alcohol and drive E-Twow scooter.
Folding steps 1. Open the lock lever, in the direction of arrow, as shown in figure (a). 2. Press the red button, figure (b), at the same time press down handlebars as shown in figure (c) and push the lock lever to the lock position. 3.
Unfolding steps 1. Press the rear brake in the direction of the arrow in the figure (a) until the folding hook release from the opening located on the rear brake. Then, lift the handlebar until it reaches the working position and the locking bolt comes into place, like in figure (b).
OPERATION 1. Introduction of Handlebar parts 1. Thumb Accelerator 2. Thumb Electronic Magnetic Brake 3. Switch Button 4. Setting Button 5. On/Off Light Button 6. Horn Button 7. Led Headlight 8. Handlebar Fold Button 9. Display 2. Operating Instructions a. ON/OFF Press the switch for 1 sec, and the display will light indicating the power is on.
Page 11
c. Breaking Control Press the left thumb and the electronic magnetic brake will operate. The greater pressure you put, the greater breaking force will be. d. Horn Turn on the power, when pressing the horn button it will hoot. e. LED Headlight In manual mode: Press the On/Off Light button when needed and there will be a sign in display indicates the light is turn on.
3. Display Factory Setting To access the menu P0 and P1 please press at the same time the switch and setting buttons. Pressing the setting button helps you switch between P0 and Both menus have other two submenus : 0 and 1, as follows: P00 (a) - displays the speed in km/h and temperature in Celsius degrees P01 (b) –...
The greater pressure you put, the greater breaking force will be. 2. E-Twow also has a rear foot brake that triggers the motor brake immediately in addition to a friction brake on the back wheel. So whatever...
brake. The electronic brake activates kinetic energy recovery system. Cruise control You can set up the speed as you want during the driving, and the scooter will start moving on the same speed afterwards. Press the acceleration right thumb and keep the same speed for 5 seconds and the cruise control will automatically enter.
Battery When you get the E-Twow electric scooter for the first time, please charge the battery fully before using. The battery can be charged at any time, in order to ensure that the battery has power, during which the battery will not charge for any damage.
MAINTENANCE Lubricating Please add a small amount of grease or lubricants to handle folded position every six months. Please check scooter every three months if the screws are loose it up. Battery The lithium polymer batteries provided by our company can be recharged at least 500 times, the normal use can reach more than 1,000 times.
GENERAL TROUBLESHOOTING Checklist When the products have any problems, please refer to the following methods. 1. LED display black screen Reason: Exposure under the sun for too long. Solution: Place it in shadow and it will return to normal after a period. 2.