First Use - U-Line U-2245RINT-00B Quick Start Manual

QUICK START GUIDE
2200 SERIES ZWC
CONTROL FUNCTION GUIDE
FUNCTION
ON/OFF
Toggle lights
Adjust temperature
View temperature in unit
Toggle between F/C

First Use

All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product.
Up Down
COMMAND
Press and release
Press and release
Press or and release
Press or to adjust set point
temperature
Press to change zones
Press to adjust set point
or
temperature
Press to confirm and exit
Press and together and release
Hold and for 5 seconds
Light Power Auxiliary
DISPLAY/OPTIONS
Unit will immediately turn ON or OFF.
Leave interior light on for 3 hours.
The zone you are setting will have its light turned on
(top zone first).
Display will show the set temperature.
Light will switch from top zone to the bottom zone.
Display will show the set temperature.
The display will flash and then toggle from set point
to temperature in unit. The temperature shown will
correspond to the illuminated zone.
The display will change units.
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press
switch on. To turn the unit off, press
9
u-line.com
Alert
LED
and the unit will immediately
.