Advertisement
MAINTENANCE
• Little maintainance is necessary if the pump is used according to the instructions in this
manual.
• If dirt builds up in the intake, rinse using running water, but remember to always unplug
from the power first.
• A 30mA (or less) Residual Current Device (RCD) must be fitted to the mains supply.
• To clean the pump remove the impellor housing and impellor. Use clean water and a
small brush to remove debris. Never use harsh cleaners or chemical solutions for clean-
ing the pump (this may cause permanent damage)
• It is not possible to remove the axle.
IF THE PUMP CEASES TO FUNCTION, CHECK FOLLOWING:
• Check the switch/circuit breaker and try another socket in order to check that the pump
has electricity supply.
• Check that the hoses or the outflow are not blocked. A garden hose can be used to flush
out any algae.
• Check the filter inlet and clear possible dirt.
• Remove the pump inlet in order to come to the rotor. Check that it is not broken or
blocked.
If the pump is maintained monthly the length of life will be extended.
WINTER MONTHS
• Protect your pump against frost.
• Take your pump from the water for the frost period and store indors.
• Clean the pump when necessary as previously described in the directions for use.
• Keep your pump in a frost-free place so it can dry out.
shaft cover
sealing ring
water leave
front cover
regulator
shaft
impeller
water leave seating
plug
Advertisement
