EA0045RC ELECTRIC FIREPLACE SAVE THIS MANUAL You will need this manual for safety instructions, operation procedures, and warranty. Put it and the original invoice in a safe, dry place for future reference. Table of Contents PAGE IMPORTANT SATETY INSTRUCTIONS DIMENSIONS...
IMPORTANT SAFETY INSTRUCTIONS: Warning: Any use of this appliance other than recommended by the manufacturer in these users manual may cause fire, burns, electric shock and /or other serious injuries When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons including the following: Read all instructions before using this appliance.
DIMENSIONS: TECHNICAL SPECIFICATIONS Model# EA0045RC Rate Voltage AC 120V, 60Hz Rate Power(Total) 1400W Power of Heating Apparatus 650W/1300W Flame Power Motor Power Specification of the Bulb 2 pcs E12 - 2 -...
ELECTRIC STOVE INSTALLATION Plugging in the heater NOTE: 1. This heater is for use on 120 Volts. 2. A 15AMP circuit is required to operate this appliance. If the breaker trips when the appliance is running, you may need to move the appliance to another location or unplug other appliances that are on the same circuit 3.
OPERATING INSTRUCTIONS NOTE: When you first turn the heater on, it may emit a slight but harmless odor. This odor results from certain oils or greases being heated as the appliance is used for the first time. This odor is perfectly safe and will stop shortly, it will not reoccur after the first operation of the appliance.
Using the Remote Control This heater includes a remote control. To operate the appliance using the remote control, the Master Power Switch (A) must be the “ON” position. See below for directions to use the remote control: Note Light bulbs may become loose during shipping. If the flame effect is dim or does not operate properly at first, ensure that the light bulbs are properly secured in the sockets (bulbs should be finger tight, do not over tighten).
CLEANING To remove dust from glass window, please use clean dry cloth. To remove fingerprints or other marks from glass window, please use clean damp cloth. Do not spray glass cleaner or other liquids directly onto the window. Clean metal surfaces with a clean damp cloth making sure not to push dust or debris into any air intake or exhaust vents.
Page 8
For service within the warranty period, please contact the store where the product was purchased. Product model number and proof of purchase are required for any service request. We reserve the right to repair or replace the defective product, as its discretion Normal wear and tear, including accessory wear, it not covered under this warranty.
Need help?
Do you have a question about the EA0045RC and is the answer not in the manual?
Questions and answers