resi-linx RL-BV240A Installation Manual

www.resi-linx.com
INSTALLATION MANUAL
RJ45 Output
A
B
C
Transmitter
Cable Requirements
4 pair twisted cable
Hardware Connection
1. Ensure all power to equipment is switched off prior to
installation.
RL-BV240A
2. Connect RCA cables from Component source to terminals
A of Transmitter.
3. Connect RCA cable from Digital Audio ouput on
Component source to Digital Audio input C of transmitter
4. Connect audio cable from Analogue Audio output on
Component source to Analogue Audio input G on
transmitter (if required)
5. Connect a second RCA cable from loop through terminals
B of Transmitter to the Component input of the local AV
device (TV, etc).
6. Connect RL-IR700/800* IR emitter to output D of
Transmitter. Place the other end within 25cm of the
IR receiver on the Component source (depending on
environmental conditions).
7. Connect 2 x RJ45 sockets of Transmitter (OUTPUT IA
and OUTPUT IIA) to corresponding INPUT I and INPUT
II Receiver in zone A via 4 pair twisted cable. Repeat for
zones B, C and D. (eg. OUTPUT IB and II B to zone B
INPUT I and II)
WARRANTY
Vcomm Pty Ltd states that the warrant that the customer can rely on is that
provided by the manufacturer. In the event of any warranty claim please
contact us and we will forward it to the manufacturer. The manufacturer will
then determine the extent of their liability. This expressly negates, to the
extent possible by Australian law, any warranty reliance on Vcomm Pty Ltd.
®
'linx-AV' Quad IR Component Video/Audio Balun Transmitter (1:4)
RJ45 Input
J
RL-BV250B
G
RL-BV240A
IR
D E F
Receiver
IR Component Video/Audio Balun Receiver
K
H I
RL-BV250B
8. Connect Component Video RCA lead (red, green,
blue) from RCA Video output
corresponding input on the component device (TV, etc).
9. Connect Digital Audio RCA lead (orange) from RCA
Digital Audio output
input on the component device (TV, etc).
10. Connect Analogue Audio lead (green) from Analogue
Audio output
the component device (TV, etc).
11. Connect RL-BV500* IR target to input
Flat target can be easily mounted (either directly using
adhesive backing, or by using RL-ACC150* Target
Mount) to the desired location, anywhere within the line
of sight of remote controls.
12. Repeat steps 8 - 11 for connection of zones B, C and D.
13. Connect supplied 12V DC switch mode power pack to
power input F on Transmitter.
14. Once installation is complete, switch on power to
all equipment. Check green PWR LE D
Transmitter is illuminated.
AV Distribution Range
RL-BV240A / RL-BV250B
A RCA Component Video inputs
B Loop Through RCA Comp. Video outputs
C RCA Digital Audio input
and Loop Through output
D IR Emitter output
E IR / Power LED's
F 12V DC Power input
G Analogue Audio input
H RCA Component Video output
I RCA Digital Audio output
J IR Target input
K Analogue Audio output
H
I of Receiver to the corresponding
K of Receiver to corresponding input of
of Receiver to the
J of Receiver.
E on
* Sold separately
Vcomm Pty Ltd
ABN: 99 091 281 524