Summary of Contents for Velleman HAA77
- Page 1 CARBON MONOXIDE DETECTOR KOOLSTOFMONOXIDEDETECTOR DETECTEUR DE MONOXYDE DE CARBONE HAA77...
- Page 2 Where the normal ambient temperature is situated below freezing point or exceeds 40 degrees C. e) In a bathroom where it could easily be splashed with water or affected by condensation. f) In a room that is not equipped with a constant electric power supply. HAA77...
- Page 3 CO DETECTOR PLACEMENT FOR BEDROOM CO DETECTOR PLACEMENT FOR MINIMUM SECURITY MAXIMUM SECURITY CO DETECTOR PLACEMENT FOR MAXIMUM SECURITY CEILING DINING ROOM KITCHEN BEDROOM BEDROOM LIVING ROOM BEDROOM FLOOR CO DETECTOR PLACEMENT FOR MINIMUM SECURITY CO DETECTOR PLACEMENT FOR MAXIMUM SECURITY HAA77...
- Page 4 The green LED should light up when the device is switched on. Your HAA77 requires a ten-minute warm-up, during which the red LED will flash. The buzzer will sound for at least 4 minutes and the red LED will flash if a CO- concentration of 100ppm or more is detected for more than 7 minutes running.
- Page 5 TEST/RESET In order to test the detector : press the POWER button firmly. The HAA77 will produce an intermittent buzzing sound and the red LED will flash. This indicates that the detector is now operational. To reset the detector when in alarm mode, press the Test/Reset button momentarily but firmly to silence the alarm.
- Page 6 • Lights up when the • Press firmly to reset detector is activated. the unit so that it monitors CO-levels again. Red LED Lamp • Lights up under test or Buzzer Cover alarm conditions. • Cover for audible alarm. HAA77...
Need help?
Do you have a question about the HAA77 and is the answer not in the manual?
Questions and answers