Logging In To The Web Management Page; Setting Dial-Up Connection Parameters - Huawei HG531 V1 User Manual

On MAC OS X
1. Choose System Preferences > Network > Advanced.
2. Click AirPort, and choose Advanced in the lower right corner.
3. Click TCP/IP tab.
4. Select Automatically in Configure IPv4, and click OK.
5. Click Apply.

Logging In to the Web Management Page

The HG531 V1 provides an intuitive web management page where you can view or set the HG531 V1
parameters.
Before you log in to the HG531 V1 web management page, ensure that the computer used for the login is
connected to the HG531 V1 and has been configured to automatically obtain an IP address or assigned
with a static IP address.
1. Open a browser. In the address box, enter 192.168.1.1. Press Enter.
2. Enter the login user name (user by default) and password (@User1234 by default). Click Login.
To protect against unauthorized access, change the user name and password after the first login.

Setting Dial-Up Connection Parameters

The HG531 V1 works in bridge mode by default. You need to install and configure a dial-up connection
on your computer, and perform it each startup.
Before setting dial-up connection parameters, verify that the HG531 V1 is correctly connected to your
computer and you have the dial-up connection account name and password provided by your Internet
service provider (ISP). This section demonstrates how to set up a Point-to-Point Protocol over Ethernet
(PPPoE) connection on Windows.
On Windows 7
1. Choose Start > Control Panel > Network and Internet > Network and Sharing Center.
2. Under Change your networking settings, click Set up a new connection or network.
3. In the Set Up a Connection or Network window, select Connect to the Internet and click Next.
4. Click Broadband (PPPoE).
5. In User name and Password, enter the dial-up connection account name and password provided by your
ISP. In Connection name, name the dial-up connection. Select or deselect Allow other people to use this
connection. Then click Connect.
7