Master / Slave Operational Mode - Philips SL ParBlazer 100 UV Installation & User Manual

Installation & User's Manual

4. Master / Slave Operational Mode

The Master / Slave Operational Mode allows one SL ParBlazer 100 UV to act as the "Master" unit and all other
connected units are controlled by this unit. When a unit is set to "Slave" mode, it will only listen to and follow any
commands sent from a "Master" unit. Only one "Master" unit is allowed in this type of operation.
Note: For more information on DMX512 networking and systems, refer to
page 1. For SL ParBlazer 100 UV DMX Mapping, refer to
DMX512
(from console or
control device)
Master / Slave Operational Mode
12
Master Unit
DMX512 (
out from first
to second luminaire)
Figure 10: SL ParBlazer 100 UV- Master / Slave Configuration
"DMX CONTROL" on page 16.
Slave Unit
DMX512 (out to the next
luminaire or DMX512 controlled
device)
SL ParBlazer 100 UV
"Additional Resources for DMX512" on
Slave Unit