Bluesky CLT-777 Operating Manual

TROUBLESHOOTING
SYMPT SOLUTION
OM
•
No dial
Check to see if the handset battery pack is connected inside
tone
the handset battery compartment.
•
Make sure that the adaptor plug is connected to the base unit.
•
Check for the telephone line cord connections. Ensure that
both connectors are plugged securely on the jacks.
•
Test the phone at a different telephone wall jack and listen for a dial tone.
•
Test a different phone in the wall jack and listen for a dial tone.
•
Will not The phone or another phone connected to the same line may
ring be in the off-hook (IN USE) position.
•
Try a different phone, if the problem still exists, the fault is not with the unit.
•
Static
The rechargeable battery pack might be weak. Allow the rechargeable
battery pack to charge fully before using.
•
Try a different phone, if the problem still exists, the fault is not with the unit.
•
Some atmospheric conditions such as very low humidity can cause
static build-up.
•
Cannot
Press the TALK button on the handset and listen for a dial tone before
dial out
dialing out.
•
Are you in a rotary only area? Set the TONE/PULSE switch to PULSE.
•
Try a different phone in the jack. If the problem persists, the fault is not
in the unit.
•
Is the phone connected to an answering machine? Disconnect the
answering machine and try to have the phone plugged into the jack
alone. If it works alone, there is a compatibility problem. Purchase
a 2 for 1 adaptor at any phone or electrical supply store. Plug the
2 for 1 adaptor into the modular wall jack, and then plug the phone
into one side and the answering machine on the other side of the adaptor.
•
Memory
Make sure that the unit is in the standby mode before storing a phon
feature
number.
•
does not
The maximum number of digits that you can store for each memory
work
location is 32 digits. See the "Memory Dialing" section for more details.
•
No link
You may have taken the handset at a distance away from the base
between that is beyond its normal operating range. Refer to the section of
the base "Operating Range" in the manual for more details.
and
handset
AC ADAPTOR: USE ONLY WITH CLASS 2 POWER SOURCE, RATED
OUTPUT 6VDC, 200mA.
THIS SYMBOL IS INTENDED TO ALERT THE USER OF THE
PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE OWNER'S MANUAL.
Operating Manual
CLT-777
Cordless Caller ID Phone
BLUEsky