Page 1
Space Cooler Model Series: AC100 & AC200 Owner’s Manual READ AND SAVE THESE INSTRUCTIONS CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. Failure to comply with instructions could result in personal injury and/or property damage.
Do not use this product with a damaged or missing filter. To reduce the risk of personal injury, the product should not be used as a toy or placed where children can reach it. Close supervision is necessary when any appliance is used near children. AC100/200 series Rev. 1/15...
Page 3
20. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on power cord. 21. Risk of fire. Do not replace the provided power supply device. Only use certified power supply rated for this product. Discard product if the attachment plug is damaged. AC100/200 series Rev. 1/15...
Do not insert anything into the fan guards. If moving the product to a different location, turn it OFF and unplug it from the outlet. ! Clean and clear any dirt or dust from the space cooler to prevent water contamination. Cooling Dial AC100/200 series Rev. 1/15...
Page 5
! Increase the density by turning the cooling dial to the left. ! Decrease the density by turning the cooling dial to the right. Operating Tips For dry climates, increasing the cooling density will provide maximum cooling results. In humid climates, a reduced cooling density is recommended. AC100/200 series Rev. 1/15...
6. Push the hose into the push-in connectors to connect the filters (fig.10). Be sure to fully insert the hose into the connector. 7. Reconnect power and test system for water leaks. 8. Reinstall filter access door (fig.9). AC100/200 series Rev. 1/15...
• Add a few drops unscented chlorine bleach to the water tank (approximately 5 drops per gallon of clean water). • Replace cap and hand tighten. • Run system for 5 minutes with high density cooling then adjust to your personal comfort level. • The system is conditioned and ready for operation. AC100/200 series Rev. 1/15...
1. Adjust the Cooling Dial balanced on 2. Low water level 2. Check water level and fill if needed both nozzles 3. Check assembly to ensure hoses (AC200 series 3. Water hose leaks are routed installed correctly. only) AC100/200 series Rev. 1/15...
In case that any mechanical or electrical repairs are required during the warranty period, send your complete product, postage or freight prepaid to the Culer customer service center near you. Call the number below to get the nearest service center.
Need help?
Do you have a question about the AC100 and is the answer not in the manual?
Questions and answers