Advertisement
Quick Links
Advertisement
Summary of Contents for Qualitel C33R
- Page 1 C33R Repeater User manual...
-
Page 2: Getting To Know Your Repeater
Getting to know your Repeater LED INDICATOR STATUS: Off = Power supply is off Blue (Double flash) = Repeater in use with good signal Red/Blue = In registration mode Purple (Steady) = Weak link to telephone base station Blue (Triple flash) = Registration completed successfully Purple (Double flash) = Repeater in use with weak link to base station Blue (Steady) = Good link to telephone base station... - Page 3 Setting up Connect the mains power adaptor Plug the small end of the power adaptor cable into the socket on the back of the Repeater. Then plug the other end into the mains wall socket but don’t switch the power on at the wall socket yet. Use a power socket close to your telephone base station.
- Page 4 Automatic registration to the telephone base station 1. Before beginning registration, make sure that all unregistered Repeaters are switched off. 2. Turn on the Repeater mode in the telephone base station that you will be registering the Repeater to. This varies dependant on the product, the instruction can be found in the User guide, provided with the telephone base station.
-
Page 5: Manual Registration (Optional)
Manual registration (optional) You can also register the Repeater manually if you prefer. 1. Before beginning registration, make sure that all unregistered Repeaters are switched off. 2. Turn on the Repeater mode in the telephone base station that you will be registering the Repeater to. This varies dependant on the product, the instruction can be found in the User guide, provided with the telephone base station. - Page 6 The unit may be left free standing or mounted on a wall. See diagram below for reference only. The screws should be fixed at 92mm apart horizontally. WARNING QUALITEL TRANSMISSION recommends that you seek advice from a building professional before attempting to wall mount your Repeater. QUALITEL TRANSMISSION is not responsible for any damage/injury caused while attempting to wall mount your Repeater.
-
Page 7: Location Tips
Using your QUALITEL DECT Repeater Location tips: Once registered, the Repeater can be positioned anywhere within the reception range of the telephone base station, preferably towards the direction you wish to • place as high as possible, at least 1.8 extend the range. - Page 8 Please note 1. Switch off the handset within the new reception range of the Repeater but outside the reception range of the telephone base station, and then switch it Blind spots (where signal is weak) can cause back on again. loss of signal.
- Page 9 Help The Repeater LED continues to flash on and off after the registration process has been completed • The registration process was not successful. You will have to repeat the registration process again with the telephone base station concerned. De-register the Repeater, see page 9 and register it to the base station again, see page 5. The Repeater LED continually flashes on and off when placed/mounted in the desired location •...
- Page 10 The Repeater will not register • Reset the Repeater as described on page 9. Cannot make or receive calls when in the Repeater reception range • There is no power to the Repeater. Check that the Power adaptor cable is plugged into the Repeater, the power adaptor is plugged into the mains socket and the mains power is switched on.
-
Page 11: General Information
• Do not open the Repeater. This could expose you to high Simply clean the product with a damp (not wet) cloth, or an voltages or other risks. Contact the QUALITEL DECT Repeater anti-static wipe. Do not use a dry cloth as it could cause a Helpline on +27 (0) 11 609 2033 for all repairs. - Page 12 • Do not use the QUALITEL DECT Repeater and handsets in Product disposal instructions for business users damp, humid conditions such as bathrooms. Do not expose Business users should contact their suppliers and check the any of the equipment or batteries to fire or water.
- Page 13 • The guarantee shall only apply to defects that occur within the 6 month guarantee period. • Proof of purchase is required. • The equipment is returned to QUALITEL or its agent as instructed. • This guarantee does not cover any faults or defects caused...