Ardisam Eskimo Z43 Operator's Manual

Power ice auger

Advertisement

Power Ice Auger
Operator's Manual
Models
Models
Z43, Z43T8, Z43Q8
Z51, Z51T8, Z51Q8
Z43Q9, Z43Q10
Z51Q9, Z51Q10
IB-Z43/Z51
Rev. 09/9/04
© Copyright 2004 Ardisam, Inc.
All Rights Reserved. Printed in USA.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Eskimo Z43 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ardisam Eskimo Z43

  • Page 1 Power Ice Auger Operator's Manual Models Models Z43, Z43T8, Z43Q8 Z51, Z51T8, Z51Q8 Z43Q9, Z43Q10 Z51Q9, Z51Q10 IB-Z43/Z51 Rev. 09/9/04 © Copyright 2004 Ardisam, Inc. All Rights Reserved. Printed in USA.
  • Page 2: One Year Limited Warranty

    Conditions of this warranty include: What is covered under warranty: Ardisam, Inc. will repair or replace any part defective in workmanship or material within one year after delivery of the ice auger to the original purchaser. What is not covered under warranty: This warranty applies only to products which have not been repaired or altered outside our factory.
  • Page 3: Owner's Responsibility

    • The auger should not rotate when the engine is idling. If Avoid injury! This symbol and text highlight potential it does rotate when engine is idling, contact Ardisam, Inc. for instructions. hazards or death to the operator or bystanders that may occur if the hazards or procedures are ignored.
  • Page 4: Engine Safety Precautions

    AFETY Engine Safety Precautions Gasoline Fires or Handling Fuel Safely Fuel and fuel vapors are highly flammable. Never use fuel Warning Carbon Monoxide Poisoning where a spark or flame may be present. Never use fuel All engines contain carbon monoxide in their exhaust. where a potential source of ignition could occur.
  • Page 5 AFETY Burns and Fires CAUTION The muffler, muffler guard and other parts of the engine Avoid injury! Always wear hearing protection while become extremely hot during the operation of the engine. operating engine. These parts remain extremely hot after the engine has stopped.
  • Page 6: Normal Operation

    OPERATION Mixing Fuel and Filling Fuel Tank Filling Fuel Tank 1. Shut-off engine and allow engine to completely cool before refilling the fuel tank. CAUTION 2. Move to a well ventilated area, outdoors, away from flames and sparks. Avoid injury! Never store engine with fuel in the tank indoors.
  • Page 7: Starting And Stopping Engine

    3. Remove all debris from air cleaner holes and fuel cap to Avoid injury! If engine fails to start after the above ensure proper air flow. operations, please contact Ardisam, Inc. at 1-800-345- 6007. 4. Turn switch to the ON position.
  • Page 8: Auger Maintenance

    MAINTENANCE Cooling Fins CAUTION • Cooling fins, air inlets and linkages must be free from any debris before each use. To prevent accidental starting: Avoid injury! Engine must be turned off and cool, and Air Filters spark plug wire must be removed from spark plug •...
  • Page 9 TRAN PORTING AND TORAGE Transporting Your Ice Auger Long Term Storage • If your ice auger will not be ran for more than one month, 1. Never transport engine inside an enclosed space or vehicle. Fuel or fuel vapors may ignite causing serious prepare it for long term storage.
  • Page 10 DO NOT DAMAGE END OF POINT. At Ardisam, we build quality and durability into the design of NOTE: When installing holder in auger shaft, edges of our products; but no amount of careful design by us, and holder may shave off.
  • Page 11: Troubleshooting

    To order from the 2. Part description factory, call or write to: 3. Quantity 4. Model number and serial number Ardisam, Inc. 1690 Elm Street, Cumberland, WI 54829 Phone (715) 822-2415 Fax (715) 822-4180 CAUTION 1-800-345-6007 Email info@ardisam.com...
  • Page 12 Z43 & Z51 HARK ENGINE PART LI T Page 12...
  • Page 13 Z43 & Z51 HARK ENGINE PART LI T MINIMUM ORDER ................$10.00 POWERHEAD PARTS Part # Description Qty. Part # Description Qty. 1021 Rocker Switch 300471 Bolt, M5 x 12mm 300401 Fuel Tank Cap 300472 Ignition Coil 300412 Clutch Spring 300473 Cover, Muffler 300429...
  • Page 14 Z43 & Z51 HARK PART LI T Page 14...
  • Page 15 Z43 & Z51 HARK PART LI T MINIMUM ORDER ................$10.00 POWERHEAD PARTS POWER AUGER PARTS Part # Description Qty. Part # Description Qty. 1023 Bolt, M6 x 1 x 16mm 232A Blade Protector, fits 6”-8" quantum auger(incl. 8651) 8912 44T Gear 233A Blade Protector, fits 9”...
  • Page 16 Ardisam, Inc. 1690 Elm Street, Cumberland, Wisconsin 54829 Phone (715)822-2415 • Fax (715)822-4180 1-800-345-6007 Email info@ardisam.com www.ardisam.com...

Table of Contents