Table of Contents
Advertisement
Quick Links
USB 4111
TFT LCD MONITOR
Introduction
Thank you for purchasing our headrest TFT LCD monitor. Before connec-
ting, operating or adjusting this product, please read these instructions
completely to ensure that your monitor performs best.
1.Do not perform any repairs by yourself, if any trouble occurs, please
immediately shut down the monitor and contact our company or local dea-
ler. This monitor is composed of many precise electronic components. Any
detachment or reassembling may result in damaging the set.
2.Do not expose to humidity, dust, vapor, sunlight,etc.
3.Do not expose to extreme heat or cold.
4.Do not use thinner or any other chemical cleaner. Please use a soft cloth
to clean the monitor.
5.Prevent the set from falling.
CAUTION!
To ensure security, the driver of the vehicle should not operate
or watch the monitor while driving.
Features
• Two Video Inputs, Video 2 is used for back mirror function.
• When on stand-by status and connected with car backing circuit,
monitor will start up automatically and switch to video2 display.
• 8-language selection menu
• Earphone function and built-in O.5W speaker
• One audio input
• All-round rotation picture (L/R, Up/Down)
© US Blaster Europe BV
Advertisement
Table of Contents
Summary of Contents for US Blaster USB 4111
-
Page 1: Tft Lcd Monitor
• When on stand-by status and connected with car backing circuit, monitor will start up automatically and switch to video2 display. • 8-language selection menu • Earphone function and built-in O.5W speaker • One audio input • All-round rotation picture (L/R, Up/Down) © US Blaster Europe BV... -
Page 2: Remote Control
(3) Up (7) Menu (4) Video/Video2 Switch (8) Earphone Jack Remote control Power Switch Key Mute Menu Language switch key Down Picture preset key AV1/AV2 4:3/16:9 switch L/R rotation key Game key Up/down rotation key © US Blaster Europe BV... -
Page 3: Cable Connections
When the output changes, the highlighted OSD bar will indicate altered direction with an arrow. The Minimum output is -100, the maximum out- put is +100. © US Blaster Europe BV... - Page 4 (PERSONAL) shall be adjusted according to personal preference and memorized in EEPROM for recalling. • Press P.P. key and it will cycle as follows: Dynamic Standard Mild L (Normal status) Memory © US Blaster Europe BV...
- Page 5 168.25 - 464.25 MHz 471.25 - 863.25 MHz NTSC VAF-L 55.25 - 163.25 MHz VAF-H 169.25 - 463.25 MHz 469.25 - 863.25 MHz SECAM VAF-L 49.75 - 160.25 MHz VAF-H 168.25 - 464.25 MHz 471.25 - 863.25 MHz © US Blaster Europe BV...
- Page 6 Remove small sections at a time, using the pull up and cut method for uniform depth. Use a Dremel or other appropriate tool to remove other obstructions. Insert the monitor to mea- sure the fit and make adjustments if necessary. © US Blaster Europe BV...
- Page 7 • Adjust the bracket pin to 90 , run the cable through the frame as shown in the diagram and connect it. Insert the monitor • Push to insert the monitor to the headrest frame. © US Blaster Europe BV...
- Page 8 USB 4111 TFT LCD MONITOR Installation of the headrest mainframe Bracket Use bracket for stand Pedestal Screw Bracket Headrest mainframe © US Blaster Europe BV...
Need help?
Do you have a question about the USB 4111 and is the answer not in the manual?
Questions and answers