Tm-I Settings; Ip Address Settings - Epson TM-T88V-DT User Manual

TM-i Settings

Configure the following settings to TM-i.
❏ IP Address Settings
❏ Registration of TM Printer
❏ Server Direct Print Settings

IP Address Settings

There are two ways of setting IP address of TM-i.
 Automatic Setting Using DHCP
 Manual Setting Using EPSON TMNet WebConfig
Automatic Setting Using DHCP
1
Make sure the power of TM-i is turned off, and then connect it to the network.
2
Turn on the TM-i.
IP address is obtained automatically by DHCP .
3
If automatic acquisition of IP address using DHCP successed, the IP address is
printed.
If automatic acquisition of IP address using DHCP fails, the IP address is set to
"192.168.192.168".
Manual Setting Using EPSON TMNet WebConfig
1
Start the setup computer.
2
Connect all TM printers to the network and power on.
3
Start the Web browser on the setup computer and enter as follows:
<TM-i Firmware ver.3.x or earlier>
http://[IP address of the TM-i]/PrinterConfigurationPage/
<TM-i Firmware ver.4.0 or later>
http://[IP address of the TM-i]/webconfig
4
EPSON TMNet WebConfig will start. Make the network setting.
For detail, refer to Technical Reference Guide of each TM-i. After making the setting, click [Apply].
5
Print the TM-i status sheet and check the network setting.
(p. 23)
(p. 24)
(p. 27)
Chapter 2 Sample Program
23
2