Bluetooth Phone/Devices; Bluetooth Controls; Audio System - Buick 2016 Verano Intellink Owner's Manual

76

Bluetooth Phone/Devices

Bluetooth Phone/
Devices
Bluetooth
Overview
For vehicles equipped with
Bluetooth capability, the system can
interact with many cell phones and
devices, allowing:
Placing and receiving hands-free
calls.
Sharing of the cell phone s
address book or contact list with
the vehicle. The phone book will
only display when that phone is
connected.
Placing outgoing calls by voice
recognition.
The system can be used while in
ON/RUN, ACC/ACCESSORY,
or Retained Accessory Power
(RAP). The range of the Bluetooth
system can be up to 9.1 m (30 ft).
The radio can connect to most
Bluetooth-enabled phones.
Available features and functions
may be dependent on the device.
On a current phone call screen, an
image of the contact from your
phone's contact list can be
displayed. Not all phones are
compatible with this feature.

Bluetooth Controls

Use the buttons on the infotainment
system and the steering wheel to
operate the Bluetooth system.
Steering Wheel Controls
/ (Push to Talk) : Press to
answer incoming calls and start
voice recognition.
/ (Mute/End Call) : Press to
end a call, decline an incoming call,
or cancel voice recognition.
+ (Volume) : Press + or
increase or decrease the volume.
Infotainment System Controls
For information about how to
navigate the menu system using the
infotainment controls, see
Overview 0 2.
V
/ (Phone/Mute) : Press to
enter the Phone main menu. Press
and hold to mute or unmute.
Voice Recognition
The voice recognition system uses
commands to control the system
and dial phone numbers.
When using voice recognition:
The system may not recognize
voice commands if there is too
much background noise.
A tone sounds to indicate that
the system is ready for a voice
command. Wait for the tone and
then speak.
Speak clearly in a calm and
natural voice.
See Voice Recognition 0 69.

Audio System

to
Sound comes through the vehicle's
front audio system speakers and
overrides the audio system. Use the
O
/VOL knob during a call to
change the volume level. The