Cable Box Connections; Cable Box (W/Rf In/Outputs) - Magnavox 14MS2331/17, 20MS2331/17, 20MS2331/37R User Manual

Magnavox color tv user manual

Hide thumbs Also See for 14MS2331/17, 20MS2331/17, 20MS2331/37R:

User manual (35 pages)

Table Of Contents

Table of Contents

f you cable signal uses a cable box or

decoder, follow the easy steps below to

complete the connection.

Cable Box (w/RF In/Outputs):

This connection will be mono.

Connect the Cable Company

supplied cable to the signal

IN(put) plug on the back of the

Cable Box.

Using a separate round coaxial

cable, connect one end to the

OUT(put) (TO TV) plug on

the back of the Cable Box.

Connect the other end of the

round coaxial cable to the 75Ω

input on the back of the television.

Screw it down finger tight.

NOTE: If applicable, set the OUTPUT

CHANNEL SWITCH on the back of the

cable box to CH 3 or 4. Tune the TV to

the same channel and change channels

at the cable box. In some cases, the

cable box will automatically tune to

either channel 3 or 4, change channels

until the picture appears.

Helpful Hints

If no Video Signal is present, the TV

will shut itself off in about 10 minutes.

If the TV is tuned to the AV channel

and there is no Video Signal present,

the screen will remain black and the

TV will shut itself off in about 10 min-

utes.