Summary of Contents for Iqinvision X2
- Page 1 X2 Outdoor Housing Installation Instructions ® When you can’t afford to miss a thing.
-
Page 2: Important Safeguards
Important Safeguards Read Instructions - All the safety and operating Power Sources - This unit should be operated instructions should be read before the unit is only from the type of power source indicated on operated. the marking label. If you are not sure of the type of power supply you plan to use, consult your Retain Instructions - The safety and operating appliance dealer or local power company. - Page 3 Damage Requiring Service - Unplug the unit Replacement Parts - When replacement parts from the outlet and refer servicing to qualified are required, be sure the service technician has service personnel under the following conditions: used replacement parts specified by the manufac- a.
-
Page 4: Table Of Contents
2. Service Unpack carefully. This is mechanical equipment If the unit ever needs repair service or parts, the and should be handled with care. Check for the customer should contact IQinVision. following: IQinvision Housing (with correct model number). 3005 S. El Camino Real... -
Page 5: Description
4. Description 5.3. Cable Requirements The X2 Outdoor Housing, specifically designed Data Transmission (Ethernet) for the IQ5XX Series megapixel cameras, offers Cable Type: Cat5e for runs < 328 ft (100 m). an easy to install, compact, sleek design that Cable Size: Outside diameter between 4.6mm... -
Page 6: Housing Mounting
5.4. Housing Mounting To mount the camera housing: a. Slide the mounting head attached to the The supplied feed-through wall mount is housings base over the wall mount. designed for camera housing installations up to 20lb (9kg) rated load. The mount is made of b. -
Page 7: Camera/Lens Installation
Loosen the front screw on the top of the sun- 5.6. Camera/Lens shield. Lift up on the sunshield and adjust back- Installation ward. See Figure 3. Loosen the single screw holding the camera sled NOTE: Do not remove the screw from the top of to the base. -
Page 8: Fittings
If a sealant is to be used, be sure it is a neutral cure type. Sealants that release acetic acid may harm camera electronics. Use of “drip loops” is recommended on the wiring outside of the rear end cap. 5.8. Conduit These housings are designed to allow conduit to be directly connected. -
Page 9: Power Connections
Route the power cable through one of the 1/2-inch NPT fittings on the rear cap or one of the feed- through fittings on the base. The terminal block provided accepts wire ranging from 20 to 14 AWG or 1.5 mm . -
Page 10: Data Transmission (Ethernet) Connection
5.11. Data Transmission To terminate a CAT5 cable you will need to use (Ethernet) Connection RJ-45 connectors and a crimping tool. Look at the 568A diagram and match the colors on both plugs. The green/white wire should be on the left WARNING: Only use the cables with the tab of the RJ-45 connector facing down. -
Page 11: Specifications
6. The sunshield can be adjusted forward or back Secure the sunshield by tightening the top and to obtain the desired amount of front coverage. the back two screws. See Figure 12. Figure 12 6. Specifications 9.42" 239.27mm 11.71" 297.43mm 5.24"... - Page 12 When you can’t afford to miss a thing. 3005 S. El Camino Real ® San Clemente, CA 92672 USA phone +1.949.369.8100 fax +1.949.369.8105 www.iqeye.com 901-0004...
Need help?
Do you have a question about the X2 and is the answer not in the manual?
Questions and answers