Elson EBW25 Installation And User Instructions Manual

2.5 litre boiling water dispenser

Hide thumbs

Table Of Contents

Elson 2.5 litre Boiling Water

Dispenser

Installation and User Instructions

Model: EBW25

Please read and understand these instructions before starting work.

Please leave this leaﬂ et with the user following installation.

This boiling water heater must only be installed by

Heater, ﬁ xing screws and plugs, installation and user

WARNING

qualiﬁ ed persons.

PACK CONTENTS

instructions.

36006232 Issue 2.

Table of Contents

Summary of Contents for Elson EBW25

Page 1 Elson 2.5 litre Boiling Water Dispenser Installation and User Instructions Model: EBW25 Please read and understand these instructions before starting work. Please leave this leaﬂ et with the user following installation. WARNING This boiling water heater must only be installed by qualiﬁ...
Page 2 INTRODUCTION Thank you for purchasing an Elson EBW25. The boiling water heater is manufactured to the highest standards and has been designed to meet all the latest relevant safety speciﬁ cations. This Elson water heater must be installed (Sections 1-5, p.1-8), commissioned (Section 6, p.9) and maintained (Sections 7-8, p.7-11) by a competent person.
Page 3: Component Checklist
CONNECTIONS Inlet connection -15mm ext. diameter Water entry point - bottom and rear Cable entry point - bottom and rear ELECTRICAL Model numbers 2.5kW - Elson EBW25 - 93 200 001 Electrical rating 2.3/2.5kW@230/240V Nominal capacities Model EBW25 2.5 litres...
Page 4: Important Installation Points
1.0 IMPORTANT INSTALLATION POINTS The Elson EBW25 stores and dispenses water at or close to boiling point at all times it is switched on. Due caution must be taken when choosing a location for the product to minimise misuse. Locate the unit over a draining board NOT over the sink or basin.
Page 5: Installation - Mounting
2.0 INSTALLATION - MOUNTING The EBW25 must be vertically wall mounted using the bracket supplied. Figure.1 (p.6) details the outside dimensions of the EBW25 unit. It is recommended that the unit is positioned above the draining board. If this is not possible consideration should be given to any spillages that may occur under the appliance.
Page 6 Fixing Bracket Fixing Hole Worktop Figure 1 MODEL DIMENSIONS (mm) INLET VENT INLET/ CABLE INLET/ VENT ENTRY VENT EBW25 CABLE FIXING FIXING BRACKET BRACKET BRACKET OUTLET ENTRY POINT POINT EBW25 52.5...
Page 7: Installation - Water Supply
3.0 INSTALLATION - WATER SUPPLY Select appropriate push ﬁ t connector for chosen entry position: Bottom entry water - 15mm x 15mm 90º elbow. Rear entry water- 15mm x 15mm straight. Note: Stainless or chromed pipes DO NOT provide secure connections with push ﬁ...
Page 8: Installation - Electrical Requirements
The supply should be fused 13Amp. If the EBW25 is to be unused for signiﬁ cant periods of time running costs can be reduced by switching the unit off. It is recommended that this is done automatically by incorporating a suitable timeswitch in the supply to the unit.
Page 9 6.0 COMMISSIONING The electronic control system of the EBW25 has a self commissioning and calibration function. Once the heater is installed and all services have been connected the appliance should require no further adjustment before use. Check that all electrical, water and vent pipe connections have been made and are secure.
Page 10: Maintenance
WARNING: Electronics control by switching ‘n’ (neutral), in some instances neutral terminations will be at 230 volts with respect to earth. The EBW25 incorporates an electronic scale conditioning function which will reduce the rate of scale deposition in hard water areas.
Page 11: Fault Finding
8.0 FAULT FINDING Your Elson EBW25 should give trouble free operation, however should a fault occur, the table below should allow most faults to be identiﬁ ed. Fault ﬁ nding should only be carried out by a competent person. SYMPTOM...
Page 12: Spare Parts
9.0 SPARE PARTS The following comprehensive list of spare parts is available for your Elson EBW25 water heater. Please refer to the rating label on the right hand side of your heater before ordering to ensure the correct spare parts are obtained.
Page 14 10.0 USER INSTRUCTIONS 10.1 Once installed the ﬁ lling and the heating cycles of the Elson EBW25 are completely automatic. 10.2 To dispense water, place a suitable container under the outlet spout and pull the tap handle down and towards (or pushed away) the user. The water dispensed will at all times be boiling or close to boiling point so due caution must be taken when using the product.
Page 15 This guarantee in no way affects the statutory rights of the consumer. The policy of Elson is one of continuous product development and, as such, we reserve the right to change speciﬁ cations without notice.
Page 16 Spares Stockists Electric Water Heating Co. 2 Horsecroft Place, Pinnacles, Harlow, Essex CM19 5BT Tel: 0845 0553811 E-mail: sales@ewh.co.uk Special Product Division, Units 9 & 10 Hexagon Business Centre, Springﬁ eld Road, Hayes, Middlesex UB4 0TY Tel: 020 8606 3567 Parts Center Tel: 0845 270 9800 www.partscenter.co.uk...