Recovering from power standby
When the server is in a power standby state, the power supplies are powered
and the PSU LEDs are lit, but the Power Status LED on the rear panel is not
lit.
The server will enter a standby power state due to any the following:
• The shutdown --ship --powerdown command has been issued.
• The PWR button was pressed when the server is running.
• The server has shut down automatically due to an over temperature
condition.
You can restore the server to its normal power state by either of the
following methods:
• Pressing the PWR button.
• Remove the power cables from both PSUs, wait for 10 seconds, then
reconnect the cables to the PSUs.
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide
Rebooting, shutting down, and powering off
87