Hide thumbs Also See for Basic:

Advertisement

Quick Links

Instruction Manual
www.TweakHearing.com
A sound amplifier for people who are not ready for a hearing aid.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Basic and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for tweak Basic

  • Page 1 Instruction Manual www.TweakHearing.com A sound amplifier for people who are not ready for a hearing aid. ™...
  • Page 2: Table Of Contents

    Tweak is a sophisticated sound amplifier utilizing Wearing Your Tweak innovative, patented technology. With the push Set-Up –BASIC Model of a button, Tweak allows you to select and set your desired amplification setting from a Set-Up –FOCUS Model range of acoustic alternatives. Developed by...
  • Page 3: General Description

    NOTE: Both models are the same in appearance. To determine which model you have, look at the inside of the battery door. If you see a blue dot, you have the Basic model. If there’s an empty space, you have the Focus model.
  • Page 4: Components

    See illustrations at right (Focus Model only) Keep batteries purchased through your retailer. When not in use, out of reach of be sure to turn your Tweak off by opening the pets and small battery door part way. (FIguRe 3, pg. 9) TIPS children.
  • Page 5: Preparing For Use

    Preparing for Use Inserting a Battery Tweak comes with two standard tubes (left and right). Tubes are marked Lift the notch at the edge of the battery compartment and swivel open the door of the battery compartment. with red lettering for the right ear and blue lettering for the left ear (FIguRe 3) .
  • Page 6: Wearing Your Tweak

    (continued) gently close the battery door. It should close easily; do not force place the Tweak over your ear. grab the loose end of the tubing the door closed. and gently insert the tip into the ear canal. position the retaining lock in (FIguRe 5) the bowl of the ear.
  • Page 7 To decrease volume: you are now in Amplification Setting Two. What you are doing is sampling the NOTE: If you decide later that you want to reset your Tweak to a BOTTOM PART available acoustic settings. There are different amplification setting, see page 26.
  • Page 8 Selecting Your Amplification Setting decide which setting you like best. With a fresh battery in your Tweak and wearing the Tweak, you are Once you’ve made your decision, press and HOLD the rocker switch for ready to choose an amplification setting.
  • Page 9: Daily Use

    *Available in Focus model only. and Noise. To switch between Quiet and Noise every time you turn on your Tweak, it will start out in the Quiet program, programs, press and hold the rocker switch for TWO at the amplification level you locked in previously. To switch to the Noise (2) seconds.
  • Page 10: Care

    Care The following instructions will assist in extending the life of your Tweak Wipe the exterior of the tube and tip. amplifier. use the cleaning line provided to clean the tube and tip, by pushing Cleaning the Exterior the cleaning line through the tube.
  • Page 11: Do's And Don'ts

    Tweak is ® not being worn.) If it is necessary to store your Tweak amplifiers for an extended amount of time, follow the steps below: Remove the batteries. Clean your Tweak according to instructions in this manual.
  • Page 12: Troubleshooting Tips

    Troubleshooting Tips Troubleshooting Tips (continued) DON’T leave Tweak on the radiator, near a stove, in a sunny No Sound or Not ensure that the battery door is closed. window, in a car or in any other hot place. excessive heat or Loud Enough Replace the battery.
  • Page 13 Your Tweak may need to be reset. See page 26 Try adjusting the volume. Tap the bottom part of the rocker switch to decrease volume.
  • Page 14: How To Reset

    Warranty (both models) See warranty card for more information. After wearing Tweak for a while, you may decide you want to try a Owner information different Amplification Setting than the one you initially selected. Each Tweak has a serial number (S/N) located on the underside of the amplifier.
  • Page 15 www.TweakHearing.com A PSAP is a wearable electronic product that is not intended to compensate for impaired hearing, but rather is intended for non-hearing impaired consumers to amplify sounds in the environment for a number of reasons, such as for recreational activities. PSAPs are not intended to diagnose, treat, cure or mitigate disease.

This manual is also suitable for:

Focus

Table of Contents