Psion Teklogix ST3006 Quick Start Manual

Contents of the Box:

Dependent on order (sold separately)
Power Cord
Quic k Start
Guid e
Omnii ™
6-Slot
ST3006 6-Slot Battery Charger Batte ry
Charg er
ST30 06
PN: 8000204
ISO 9001 Certified
Quality Managem ent System
AC/DC Adaptor This Guide
MT2031 Mounting Bracket Kit (contains
Wall Mount Bracket, 4 wall screws, 2
screws for Charger)
Features: Top and Bottom
Charging Compartments (6)
DC In Connector
Charge Indicator LEDs (set of 4 per compartment)
Rubber Feet (5)
Drain Holes (6) Bracket Mounting Holes (2)

Getting Started:

1
Mount the Battery Charger.
Charger Mounting holes (2)
Attach the Mounting Bracket to the
wall using the 4 screws included in
Wall Mounting
the MT2031 Mounting Bracket Kit.
holes (4)
See the location guide overleaf for
dimensions.
Screwdriver access holes (4)
Insert the two mounting screws from the Kit into the holes through the top of the
Battery Charger and tighten to the Mounting Bracket to secure it.
Mounting Holes (2)
Final position with AC/DC Adaptor in place.
Wall mount Desk mount (attachment to desk is optional)
2
Connect the Battery Charger to external power.
Warning: Use IEC-320 C13 power cords approved by Psion Teklogix, with
the ground pin connected to a proper earth-grounded receptacle. Check with
a qualified electrician if you are uncertain of your receptacle grounding.
IEC-320 C13
Notes: The LEDs light when first connected to power.
Use only the universal AC/DC power adaptor approved by Psion Teklogix
for use with the Battery Charger.
Wall bracket AC/DC adaptor
Choke
Bottom of
Charger
Power cord
DC input plug
(sold separately)
AC outlet
3
Insert one or more batteries for charging.
Insert the battery by placing
the base into the slot in line
with the pins and pivoting
the top of the battery into the
charge compartment.
Then snap the battery tabs
into place.
4
Allow the batteries to charge for four hours.
Note: Full battery performance is only reached after the first few charge/discharge
cycles. A table of the charge status indicated by the LEDs is shown overleaf.
0 - 40 °C
32 - 104 °F 4 h
Over