Page 11
Additional safety fitting to stabilisor With tailplane (Stab.) firmly screwed down, pass a 3.6mm drill through the holes in the fins and drill a hole through the metal tongue projecting down from the Stab. Remove the Stab and tap the new hole in the tongue out to 4mm thread.
Page 13
4 x 15mm Bolt 4mm Mount Nut Cut off at the dotted line 4 x 15mm Bolt 4mm Mount Nut...
Page 16
Further, Boomerang RC Jets, LLC. reserves the right to change or modify this warranty without notice. In that Boomerang RC Jets, LLC. has no control over the assembly or materials used by the builder of the model during final assembly, no liability shall be assumed nor accepted for any damage resulting from the use of the final user-assembled product.