Advertisement
Operating your Fan
Fan control switch
The control switch positions are:
• 0 = OFF
• 1 = Low Speed
Check that the Fan control switch is set to the
off position before plugging into the mains
supply.
You can control your wall fan either with the
Remote Controller or with Control Buttons on
the control panel.
Press the "ON/SPEED" button. At first start-
up the fan will operate at low speed.
Press the same button to choose between
Low, Medium and High speed.
Press "SWING" button to switch on the
oscillation mode.
Remote Control
The sensor of the remote control must be
pointed at the fan receiver to operate
properly.
The distance between the remote and
receiver should be no more than 6 metres
and 30 degrees radius left to right of the fan.
•
2 = Medium Speed
•
3 = High Speed
Timer Mode
Press this button repeatedly to change the
timer
setting.
The
increments of 0.5 hours and it has 4 time
steps in total, which add up to set your
desired timer setting. The maximum timer
setting is 7.5 hour.
For example, to set the time for 5 hours,
press the timer button repeatedly, till the
indicator lamps "1h" and "4h" are lit at the
same time.
Do not press timer button if you want to keep
your fan operating indefinitely – the timer
indicator lamps will not light up if the timer
button is not pressed.
time
increases
in
Advertisement
