AQUATECH Strike Flash Instruction Manual

Strike Flash Housing

Instruction Manual

FEATURES:

Flash Housing- Clear casing that suits
your professional flash.
Flash Bolts- Included are four M6x18
bolts. Three are used for sealing the Flash
Sport Housing and there is one extra
included for back up.
Grey Sealing O-Ring- This o-ring seals
between the Backplate and Flash Sport
Housing.
Flash Mount- Bolts to the top of your Sport Housing
using two M5x10 bolts.
Flash Bulkhead- The (black) dry connector located
on the side of your Flash Sport Housing. The flash
bulkhead is only waterproof if the cap is on or if the
sync cord is connected.
Sync Cord- The 16 inch (400mm) cable that
connects between your Flash Sport Housing and
Camera Sport Housing. This cord is only waterproof
if caps are screwed on or if it is connected to your
Flash Sport Housing and Camera Sport Housing.
Camera Hot Shoe- This piece connects to the hot
shoe of your camera then to the Flash Bulkhead
wires on the inside of your housing. This piece is
fragile so handle with care.
6mm Hex Key- This tool is used for tightening down
the Flash Sport Housing to the mount.
5mm Hex Key- This tool is used to bolt down the
Backplate.
4mm Hex Key- This tool is used to bolt down the
Flash Mount.