1. Manuals
  2. Brands
  3. Celcom Manuals
  4. Wireless Router
  5. PortaWiFi 2.0
  6. Getting to know manual

Celcom PortaWiFi 2.0 Getting To Know Manual

Hide thumbs

Advertisement

Table of Contents

PortaWiFi 2.0
Plug it. Play it. Share it.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PortaWiFi 2.0 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Celcom PortaWiFi 2.0

  • Page 1 PortaWiFi 2.0 Plug it. Play it. Share it.

  • Page 2: Overview

    Getting to Know Your Device Appearance The following figure is for your reference. The actual prod- uct may vary. 1. LED Indicators 2. Power Button 3. WPS Button 4. Micro USB Port 5. (U)SIM Card Slot 6. RESET Button 7. microSDHC Card Slot NOTE: microSDHC™...
  • Page 3 Registered to Celcom’s Green solid 2G/3G network. Network Connected to Celcom’s Green blinking 2G/3G network and data is being transferred. Registered to Celcom’s 4G Blue solid network. Connected to Celcom’s 4G Blue blinking network and data is being transferred. Blue solid Wi-Fi is active.
  • Page 4 The battery is empty. Please Red blinking charge the battery. The battery is low. Please Red solid charge the battery. Battery The battery is being Green blinking charged. The battery level is middle or Green solid high. Your device is in sleep mode LED light off and not being charged, or the battery is not inserted.
  • Page 5 Internet Wi-Fi Mode: Your device will connect to other • WLAN device (hotspot device, wireless router, etc.) via Wi-Fi to access the Internet. The WLAN device has al- ready connected to the Internet. NOTE: The subnets of your device and other WLAN devices must be different.

  • Page 6: Installing Your Device

    Installing Your Device 1. Slide the back cover and remove it 2. Insert the (U)SIM card. IMPORTANT! Your device does not support the microSIM and nanoSIM card or any other non-standard SIM cards. To avoid dam- age to the device, do not use those cards or any card hold- ers.
  • Page 7 3. Insert the microSDHC card if necessary. 4. Insert the battery. 5. Close the back cover.

  • Page 8: Connecting To Your Device

    Connecting to Your Device Using Wi-Fi 1. Power on your device directly. 2. Make sure your computer or other client devices have enabled Wi-Fi, and search for available wireless net- works. NOTE: Refer to your Wi-Fi-enabled client device manual for further details on how to search for wireless networks. If you use a computer, you need to set your computer to obtain an IP address automatically.
  • Page 9 Using a USB Cable 1. Connect a computer to your device with a USB cable. 2. Power on your device. The operating system detects and identifies new hardware, and automatically installs the hardware. NOTE: If the system does not automatically launch installation, you can click the device installation icon in My Computer to install.
  • Page 10 3. Enable the WPS function on your client to respond this authentication process. 4. Follow the system prompts on your client to finish the connection. NOTE: For the detailed operations about the client, please refer to the client’s instruction. Getting to Know the Wi-Fi SSID and Password You can view the label on the device to get the default Wi- Fi SSID and password.

  • Page 11: Accessing The Internet

    3. Select , and then click Connect or Disconnect. NOTE: If you want to modify the detailed parameters of your de- vice, please log in to the PortaWiFi by Celcom page by vis- iting http://192.168.1.1 and the default password is admin.
  • Page 12 Internet Wi-Fi Mode 1. Log in the PortaWiFi by Celcom page. 2. Select Settings > Internet Wi-Fi. 3. Enable the Internet Wi-Fi Switch, and then click Apply. 4. Connect to the WLAN device. There are two methods for your reference.

  • Page 13: Configuring Your Pc

    5. After the client connected to the WLAN device suc- cessfully, you can access the Internet. Configuring Your PC The following procedure describes how to configure the In- ternet Protocol in the Windows 7 operating system for your Wi-Fi connection. 1.

  • Page 14: Warning And Notice

    Warning and Notice To the Owner • If inadequately shielded, some electronic devices may be affected by the electromagnetic interference caused by the modem, such as the electronic system of vehi- cles. Consult the manufacturers of such devices before using the modem if necessary. •...
  • Page 15 • Do not use electronic transmission devices in aircrafts, at petrol stations or in hospitals. Observe and obey all warning signs, and turn off the modem in these condi- tions. • Do not touch the inner antenna area unless it is neces- sary.

  • Page 16: Limited Warranty

    • Do not use the modem immediately after a sudden temperature change. In such case, dew may be gener- ated inside and outside the modem, so do not use it until it becomes dry. • Handle the modem carefully. Do not drop, bend or strike it.
  • Page 17 Modifications or repairs not provided by Celcom or a Celcom-certified individual. Power failures, surges, fire, flood, accidents, and ac- tions of third parties or other events outside Celcom’s reasonable control. vi. Usage of third-party products, or usage in conjunction with third-party products if such defects are due to the combined usage.

  • Page 18: Limitation Of Liability

    Limitation of Liability Celcom shall not be liable for any loss of profits or indirect, special, incidental or consequential damages resulting from or arising out of or in connection with using of this product, no matter whether or not Celcom had been advised, knew...

  • Page 19: Troubleshooting

    Troubleshooting Problem Suggested Solution • Install the software, and run the installation program in the Cannot establish path of My Computer. the USB connection • If the driver of your device is between your device abnormal, please reinstall the and PC. software.
  • Page 20 Problem Suggested Solution • Make sure your (U)SIM card is available. • Change the location to find a The client connected place with good signal. to the device cannot • Check WAN Connection mode access the Internet. setting. • Contact with your service pro- vider and confirm your APN settings.
  • Page 21 • For the Wi-Fi connection pass- word, please check the label on the device. • The default password of the PortaWiFi by Celcom page is admin. About the password • If you changed the password and forgot the new password, you need to restore the device to the factory default settings.
  • Page 22 For more assistance, please contact: Highpoint Service Network Careline: 03-8026 6226 Subang Jaya HQ No 1, Jalan TP6, Sime UEP Industrial Park, Subang Jaya, 47600 Petaling Jaya, Selangor. Operation Hour: 9:00am to 6:00pm (Mon to Fri) Tel: 03-8026 6288 Fax: 03-8024 5100 GPS Coordinate: N 3.04556 E 101.56466 Kuala Lumpur Lot 4.20, 4...

Table of Contents

Save PDF