1. Manuals
  2. Brands
  3. BriskHeat Manuals
  4. Power Tool
  5. BRISKAIRSP-1
  6. Instruction manual

BriskHeat BRISKAIRSP-1 Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
BRISKAIRSP-1

Instruction Manual

Read and understand this material before
installing this heater. Failure to understand how
to safely install the heater could result in an
accident causing serious injury or death. This
heater should only be installed by qualified
personnel.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BRISKAIRSP-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for BriskHeat BRISKAIRSP-1

  • Page 1: Instruction Manual

    BRISKAIRSP-1 Instruction Manual Read and understand this material before installing this heater. Failure to understand how to safely install the heater could result in an accident causing serious injury or death. This heater should only be installed by qualified personnel.

  • Page 2: Table Of Contents

    For additional information ® concerning this, or other BriskHeat Hazards or unsafe practices which products, please contact us toll free COULD result in severe personal (U.S. / Canada only) at: injury or death 1-800-848-7673 or 614-294-3376.

  • Page 3: Important Safety Instructions

    The end-user is responsible for providing suita- Failure to observe these warnings may ble electrical protection device. It is highly rec- result in personal injury or damage to the ommended that a ground fault circuit breaker be heater. used. ® BriskHeat Corporation. All rights reserved...

  • Page 4: Prior To Installation

    The heater is designed to work at a specific voltage to heat properly. For additional infor- ® mation, contact BriskHeat HOT GUN SET-UP 1. Perform composite lay-up of mounting pin. 2. Place hot gun into the metal stand with the handle facing upwards (Figure 1).
  • Page 5 TTQSD S16temperature controller (Figure 4). Firugre 3 Firugre 4 6. Place the output hot gun nozzle 2” (50mm) from the bond line. Position the hot at a 20° angle pointing downward at the bond line. ® BriskHeat Corporation. All rights reserved...

  • Page 6: Operation Of Hot Gun

    Note: Hot gun blows cold air initially. 6. Start curing program by pushing red power button on front of TTQ3D-16. 7. To shut down program, push red power button on front and close toggle switch on back of TTQ3D-16. ® BriskHeat Corporation. All rights reserved...

  • Page 7: Storage And Handling

     TROUBLESHOOTING GUIDE ® Please read this guide prior to contacting BriskHeat . This guide is designed to answer the most commonly asked questions. If you are unable to identify the problem or need additional assistance, please contact your local distributor / representative or BriskHeat at 1-800-848-7673, 614-294-3376, or bhtsales1@briskheat.com.
  • Page 8 Hot Gun for Composite Curing 1055 Gibbard Ave, Columbus, OH 43201 Toll Free: 800-848-7673 Phone: 614-294-3376 Fax: 614-294-3807 Email: bhtsales1@briskheat.com Web site: www.briskheat.com ® BriskHeat Corporation. All rights reserved PN: 41231-01 Rev C...

Table of Contents