Mackie Big Knob Studio Command System Operation Manual page 8

DIM
Pressing this button turns down the signal going to
the MONITOR A, B, and C outputs by 20 dB. This
lets you turn down the speakers to converse with-
out affecting the speaker level you have set.
Note: Like the Big Knob VOLUME control, the
MONO, MUTE, and DIM buttons ONLY affect the
MONITOR A, B, and C outputs. These buttons have
no effect on the currently selected source(s) as they
are routed to the other various outputs.
POWER LED
This LED lights when the POWER switch is turned
on and Big Knob is receiving AC power. It lets you
know that Big Knob is turned on, even if no other
buttons are pressed that would light up their associ-
ated red LED.
MONITOR SELECT
A
Press this button to route the currently selected
input source(s) to the MONITOR A
B
Press this button to route the currently selected
input source(s) to the MONITOR B
C
Press this button to route the currently selected
input source(s) to the MONITOR C
Application Note: You can have one, two,
or all three MONITOR outputs turned
on at the same time. You could connect
MONITOR B to a pair of full-range speak-
ers and MONITOR C to a subwoofer. Use
the MONITOR C button as a "subwoofer
IN/OUT" switch to compare the sound with and
without the subwoofer.
INPUT
OL
8
0
4
8
DAW
24 MIX
0 = + 4dBu
PHONES
1
MAX
O O
2
MAX
O O
8
BIG KNOB
output jacks.
output jacks.
output jacks.
INPUT SOURCE SELECT
2-TRACK 2-TRACK PHONO
A B
STUDIO OUTS
PHONES/
STUDIO OUTS
SOURCE
MAX
O O
OFF
INPUT SOURCE(S)
LEVEL
ON
PHONES MIX INPUT
PHONES 1 and 2
These 1/4-inch TRS connectors output an ampli-
fied stereo signal of either the DAW PHONES MIX
INPUT or the INPUT SOURCES
depending on the position of the PHONES/STUDIO
OUT SOURCE
PHONES 1 and 2 Level Control
These rotary knobs control the volume of the stereo
signal at the PHONES 1 and 2 headphone connec-
tors. The same signal appears at both headphone
outputs, but the volumes are adjusted independently
with these level controls.
so it is best to start with the LEVEL controls turned
all the way down and then turn them up SLOWLY to
a comfortable listening level. In fact, starting right
now, get in the habit of turning down the PHONES
LEVEL controls when you are done using your
headphones so you don't plug them in later and ac-
cidentally blow out your ears!
PHONES/STUDIO OUT SOURCE Button
This button affects the stereo signal going to:
• Both headphone outputs (PHONES 1 and 2)
the front panel
• The PHONES AMP
• The STUDIO OUTS
When INPUT SOURCE(S) is selected (up), the
above outputs are fed the signal from the INPUT
SOURCE SELECT buttons. This is the same signal
that goes to the MONITOR A, B, and C outputs. In
this position, the recording engineer and the talent
can listen to the same mix (the MONITOR outs and
STUDIO/PHONES outs have the same signal).
MIC
MAX
O O
VOLUME
MONO DIM
MUTE
switch described below.
Note: Turn down the PHONES
LEVEL controls before plugging
in your headphones. The PHONES
outputs are designed to drive
headphones to a very loud level,
output on the rear panel
on the rear panel
POWER POWER
MONITOR SELECT
A B
TALKBACK
MAX
O O
TO
LEVEL 2-TRACKS
,
on
C
TO
PHONES/
STUDIO