Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Spectrum Swim-Lift Gallatin WP400
-
Page 2: Table Of Contents
Thank you for purchasing the Swim-Lift® Gallatin. Providing that the unit is installed correctly and properly maintained, it will furnish you with many years of trouble free use. It is important to read this entire manual before beginning assembly or operation. INDEX Unpacking and Inspection Material and Tool Requirements... -
Page 3: Unpacking And Inspection
You must note the damage or shortage on the freight carrier’s bill of lading before accepting shipment. It is Spectrum’s desire to provide superior products and services. Unfortunately we cannot control circumstance related to the shipment of products beyond our freight docks. -
Page 4: Assembly Drawing
ASSEMBLY DRAWING NUT NYN 5/16”-16 WASHER FW 5/16”... -
Page 5: Anchor Installation
Anchor Installation If you purchased and installed a Swim-Lift® Pre-Set Anchor previously or if your Retro- Fit Anchors are already installed, please proceed to the Lift Assembly Section on page 7. Anchor Location It is recommended that the Gallatin be installed in or near the shallow end of the pool with sufficient deck space and operational area in the pool as shown in figure 2. - Page 6 Anchor Installation 1. Mark the location of each anchor on the deck and use a ½” diameter concrete drill bit to drill a 4” deep hole at each location. Make sure to drill straight down. 2. Use a 1- 1/2" diameter concrete core drill to drill out the anchor holes to a depth of 2- 3/16”...
-
Page 7: Lift Assembly
Lift Assembly 1. Attach the base of the Cylinder Support Column Assembly with four 3/8” – 16 x 4-1/2” hex head bolts protruding from the support column, as shown in figure 1. Secure the base with four 3/8” Flat washers and four 3/8” acorn nuts, torque to 20 ft-lb. 2. - Page 8 11. Install Cover on lift as shown in figure 5. 12. Connect Flip up footrest using one 3/8” – 16 x 1 ¼” Socket head shoulder screw, a 3/8” Flat washer and, 3/8” nylock nut torque to 20 ft-lb as shown in figure 1. 13.
-
Page 9: Lift Operation
Lift Operation WARNING ! Read all of the operating instructions before operating the lift. Make sure that all individuals using the lift have read the instructions and have been made aware of all safety precautions. WARNING ! Do not exceed the maximum lifting capacity 400 lbs (181.4 kg). This may result in damage to the lift or personal injury. -
Page 10: Care And Maintenance
4. Keep other swimmers and children away from the lift at all times. Remove the lift from poolside when not in use if possible. A cover is available from Spectrum Products® to aid in preventing unauthorized use of the lift. -
Page 11: Troubleshooting
Troubleshooting... -
Page 12: Two Year Limited Warranty
Spectrum Products® agrees to repair or replace, at its sole discretion, any product that fails to perform as specified within 24 months after date of the original shipment from the factory unless otherwise noted. - Page 13 Your Rights Under State Law: This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. Spectrum Products® disclaims all liability for damage during transportation, for incidental, special or consequential damage of whatever nature, for damage due to handling, installation, or improper operation, or for damage caused by circumstances beyond Spectrum Products®...
- Page 14 ___ (1) 13900 Flip Up Footrest w/ HDPE White Footboard ___ (1) 13289 Seat Frame Assembly w/ Grips ___ (2) 26293 Molded Seat Half Top/Bottom ___ (1) Headrest Bar with Gray Spectrum Headrest ___ (1) 13890 50’ Garden Hose ___ (1) Literature...