Eclipse Security ECL-NVR16P-DH User Manual page 46


Channel: Select the current camera channel.

PTZ type: There are two types: local/remote. Please select local mode if you are connect RS485
cable to connect to the Speed dome (PTZ). Please select remote mode if you are connecting to the
network PTZ camera.

Protocol: Select corresponding PTZ protocol(such as PELCOD)

Address: Default address is 1.

Baud rate: Select corresponding baud rate. Default value is 9600.

Data bit: Select corresponding data bits. Default value is 8.

Stop bit: Select corresponding stop bits. Default value is 1.

Parity: There are three options: odd/even/none. Default setup is none.
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 4-30.
Figure 4-29
105