Downloaded From Dishwasher-Manual.com Manuals - Bosch SGS 55E32 Instructions For Use Manual

en
Note
Optimum rinsing and drying results can be
obtained by using standard detergents in
conjunction with separate application of
salt and rinse aid.
Observance of the operating instructions
or information on the packaging of the
combined detergents determines their
effectiveness.
Note
Even if the rinse aid and/or salt refill
indicator is lit, the rinse programme runs
correctly when 3in1 products are used.
If the rinse aid refill indicator
refill indicator is defective and you
6
would like to switch it off, proceed as
follows:
Switching the rinse-aid refill
indicator off or on*
*
some models
You can switch off the rinse-aid refill
indicator if you use a detergent
7
with integrated rinse-aid.
Close the door.
Press and hold down button A .
Press main switch
display lights up.
Release both buttons.
The digital display
(rinse-aid refill indicator) and the button
A flashes.
By pressing button A you can switch
the rinse-aid indicator off
Switch off the main switch
The setting is saved.
"Remember to switch on the rinse-aid refill
indicator again if you use a detergent
without an integrated rinse-aid!"
16

Downloaded from DishWasher-Manual.com Manuals

or salt
7
until the digital
1
indicates
8
or on .
;
1
Switching the salt refill
indicator / water softening
system off and on
Close the door
Rotate the programme selector
from the 12 o'clock position by one
notch to the left.
Switch on main switch
down for at least 3 sec.
The digital display
current set hardness value and the salt
refill indicator
6
(hardness value has been set to 4
at the factory).
To change the setting: Rotate the
programme selector
You can select a set value between
0 and 7 according to the hardness
of your water.
Switch off the main switch
The chosen setting has now been
stored.
Note
If you use the detergent and rinse aid
separately or switch from combined
detergents to standard cleaning products,
ensure that the rinse aid refill indicator has
been switched on and the water softening
system has been set to the correct water
hardness.
3
and hold
1
indicates the
8
flashes
.
3
.
1