Table of Contents
Advertisement
PDK-50HW2
NAME AND FUNCTION OF PARTS
<Main Unit>
Power switch
ON
Rear side
of unit
OFF
RS-232C
DC IN
DC-IN jack
RS-232C
connector
<Pen>
Tip
Cap
Pen tip
(corresponds to left mouse button)
82
Power indicator
(Lights green when ON)
NOTE:
When the power switch is first turned on, the power
indicator will flash orange; while the indicator is flashing
(about 3 seconds), do not touch the screen, since the unit is
initializing its internal settings.
Battery cover hole
LED indicator
Battery cover
Large button
(corresponds to right
mouse button)
Small button
(corresponds to middle
mouse button)
PEN
NORMAL
If pen operation becomes difficult:
The pen may fail to operate properly if the battery
cover holes are blocked. Also, the pen may begin
operating erratically when the battery becomes
depleted. In this event, change the battery at your
earliest opportunity.
Confirming Battery Life:
When the small button is depressed fully, an LED
indicator will light. If the indicator fails to light, or
lights only dimly, the battery is depleted and
should be replaced.
Mode selector switch
Set the mode switch in
accordance with whether
you will use the special
pen or other device to
input characters and lines
on the screen.
PEN Mode:
In this mode, the
special accessory
pen can be used to write
on the screen. Using the
special pen allows the
drawing of more clearly
delineated characters and
lines.
NORMAL Mode:
In this mode, your
finger or other
object can be used to write
on the screen. This mode
will produce lower screen
definition, however,
compared to drawing with
the dedicated input pen.
Plasma Display
Operation Panel
Advertisement
Table of Contents
