Table of Contents
Advertisement
Field Wiring Connections
DANGER: SHOCK HAZARD
Make sure electrical power to the heater is discon-
nected to avoid potential serious injury or damage to
components.
CONTROL/SENSOR
WIRING
HIGH VOLTAGE POWER
AND PUMP WIRING
LOCATION
Fig. 14: Rear Wiring Location
Wiring the Thermostat
Connect the Enable/Disable terminals to the PIM (shown in Fig. 16). Alternately, any dry contact closure (includ-
ing a remote thermostat) across these terminals will enable the XFyre unit to run. Caution should be used to
ensure neither of the terminals becomes connected to ground.
SUGGESTED ROUTING OF
SENSOR & CONTROL
WIRING
RATING PLATE
*
Fig. 16: XFyre Single Heater Control
CAUTION: Wiring errors can cause improper and
dangerous operation. See the wiring diagram in this
manual. Verify proper operation after servicing.
VERSA
CONTROL
PLATFORM
IGNITION MODULE
Fig. 15: Front Wiring Locations
* CAN BE MODIFIED TO ACCEPT 4-20mA
CONSULT VERSA IC MANUAL
ALARM
21
(PIM)
Advertisement
Table of Contents
