Advertisement
Start up: press the power button for 3 seconds. The green indicator light
•
will light up.
Power off: press the power button for 3 seconds again. Press the OK
•
button, then select "YES" to the confirmation question and the green
indicator light will go out.
Note: the recorder will power off automatically after the low-power alarm while
no external power source is connected.
After starting up, press the MENU key, enter the main menu and press
UP/DOWN to select "
language setup. Press UP/DOWN until you have highlighted your preferred
language, then press OK.
There are three ways to charge the battery.
1. Charge via USB cable
2. Charge via vehicle power
3. Charge via USB cable plugged into a USB wall adaptor (not included)
During charging, the red indicator light will be on and charging should take
approximately 180 minutes. Once charging is complete, the red charging
indicator will go out if you are using your car power or a USB cable with an
adaptor.
Push the micro SD card into the card slot in the direction indicated by the
markings on the camera body. When the card is fully inserted and clicks into
place, stop pushing.
Note: this unit requires a high speed Micro SD card of Class 4 or higher, up to
32GB in size.
Push the micro SD card slightly in further to the unit, at which point it will
partially pop back out of the camera.
" language setup. Press the OK key to enter into the
3
Advertisement
