Advertisement
PRODUCT FEATURES
Battery Cover
Shaver Housing
INSTRUCTIONS FOR USE
Installing the Battery
Remove the Battery Cover and insert
2 AAA batteries (not included).
Make sure the positive (+)
and negative (-) ends of the
batteries are inserted in the
battery compartment properly.
Replace the Battery Cover and
click into place. Note: Do not
mix different types of batteries.
Do not mix old and new batteries.
Always dispose of batteries properly.
Using the Nose Hair Trimmer
Remove the Blade Cap by twisting
it counterclockwise. Then, slide the
power switch to the "Nose" position.
Carefully place the blade into the nos
trils to remove unwanted hair. Use the
same procedure to remove hair from
the ear and also trim the eyebrows.
Using the Mini Shaver
Remove the Shaver Cap. Then, slide
the power switch to the "Shave/Trim"
position. Note: the Mini Shaver is for
small hairs. Hairs should be free of
lotion when using the Mini Shaver.
Using the Beard/Moustache Trimmer
Remove the Shaver Cap. Then, slide the power
switch to the "Shave/Trim" position. Slide the
Beard/Moustache Trimmer blade forward with
your thumb. Note: You can use the Beard/
Blade Cap
Moustache Trimmer for small areas, such as
hairline, sideburns, etc. Hairs should be free
of lotion when using this trimmer.
Nose Hair Trimmer
Outer Blade Housing
CLEANING AND MAINTENANCE
Be sure the Power Switch is turned off before cleaning
the device.
Cleaning the Nose Hair Trimmer
1. Switch the device off.
Power Switch
2. Remove the Outer Blade
• Nose
Housing by twisting it counter
• Off
clockwise and raising it off
• Shave/Trim
the unit.
3. Wipe the Outer Blade Housing
with a tissue to remove hairs,
dust, etc.
4. Replace the Outer Blade
Housing and twist it clockwise
to lock it in place.
• Beard/Moustache
Trimmer
Cleaning the Mini Shaver and Beard/Moustache Trimmer
• Mini Shaver
1. Thoroughly brush and blow
any visible hair from the blades.
• Shaver Cap
2. Remove the Shaver Housing
by holding the unit with the
trimmer side up and the blade
pointed away from you. Place
your thumb on the silver part
of the Mini Shaver and gently
press away from you. The
Housing will pop off for cleaning.
Note: You may rinse the Shaver
Housing with water. Do not let
water drain into the motor area.
3. To maintain your shaver in peak
condition, the blades should be oiled
every few haircuts.
Do not use hair oil,grease,oil mixed with
kerosene or any solvent. As the solvent
will evaporate and leave the thick oil which
may slow down the blades motion.
4. Allow the Shaver Housing to
dry and replace it on the unit.
-
5. Do not allow water to drain in the
trimmer`s motor area.
TROUBLESHOOTING
If the cutters do not move, the cutting areas may be clogged
or dirty. Clean the blades and make sure you have a fresh
set of batteries installed.
CUSTOMER SERVICE
If you need any assistance with your 3-in-1 Smart Groomer,
please call 1 (877) 714-7444, and select Option 3.
Advertisement
