Page 1
ICF-C723/C723L SERVICE MANUAL US Model Canadian Model Ver 1.1 E Model Australian Model ICF-C723 UK Model ICF-C723L AEP Model ICF-C723/C723L SPECIFICATIONS Radio section General Frequency range : Time display US, Canadian model US, Canadian, UK model 12-hour Band ICF-C723 Channel step...
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT blue 10.67MHz CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE orange 10.73MHz REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY black 10.64MHz DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY. white 10.76MHz...
ELECTRICAL ADJUSTMENTS • Repeat the procedures in each adjustment several times, and the AM Section frequency coverage and tracking adjustments should be finally Band button : AM (ICF-C723) done by the trimmer capacitors. : MW or LW (ICF-C723L) Volume : MAX...
Page 7
Adjustment Location : ICF-C723 [MAIN BOARD] (Component side) CT1 : AMTracking Adjustment L3 : AM Tracking Adjustment L4 : FM Tracking Adjustment T1: AM IF Alignment L5 : FM Frequency Coverage Adjustment CT3 : FM Tracking Adjustment L6 : AM Frequency Coverage Adjustment...
SECTION 4 DIAGRAMS 4-1. EXPLANATION OF IC TERMINALS IC101 µ PD17071GB-522-1A7 (SYSTEM CONTROL) Pin No. Pin name Description INIT Destination select terminal. PLAY OUT VOL – Not used (Open). POWER Mute drive output. R MUTE REC Mute drive output. PLAY Voice memo play control output.
ICF-C723/C723L 4-3. SCHEMATIC DIAGRAM (MICROCOMPUTER SECTION) WAVEFORM 1.8Vp-p 75kHz IC101 @¢ XOUT VOLT/DIV : 0.5V AC TIME/DIV : 5 µsec Note: • All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums.
ICF-C723/C723L 4-5. SCHEMATIC DIAGRAM (MAIN SECTION) Refer to page 17 for IC Block Diagram. Note: • All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. • All resistors are in Ω and W or less unless otherwise specified.
SECTION 5 EXPLODED VIEW NOTE : IC BLOCK DIAGRAM • -XX, -X mean standardized parts, so they • The mechanical parts with no reference IC1 CXA1019M may have some difference from the original number in the exploded views are not The components identified by mark or dotted line with mark ! are critical...
SECTION 6 MAIN ELECTRICAL PARTS LIST NOTE : • Due to standardization, replacements in the • SEMICONDUCTORS In each case, u : µ , for example : The components identified by mark parts list may be different from the parts uA..